Yes, but you need to scrape or chip off as much of the old mortar as you can - both from the back of the tile and from the floor, just enough to ensure that the tile will set level.
One might apply ceramic wall tiles by using either of 2 products: tile mastic or thinset mortar. The application process is the same for both products. One could use a V-notched trowel to spread some of the mortar onto the wall, covering an area just big enough to lay in about 8 tiles.
A trowel.
It is used to spread/lay mortar.
A trowel. These are flat, pointed metal tools that spread mortar around.
A gauze mat on a tripod supports the vessel being heated, and helps to spread the heat evenly, especially if it has ceramic on it.
It's no different on drywall than it is on any other surface. You spread the cement the same way, you apply the tile the same way.
It is best to remove the vinyl tile. If it is not on cement and is on wood you can install cement backer board. Be sure to put thin set under the board. If you spend the money and time to install ceramic tile and the vinyl tile comes loose all that $ is down the drain What is the best tile cement to use and this cement tile can be installed on vinyl tile and install ceramic tile on it
If the skin is not a mucus membrane, or the genital area, then if you had intact skin HIV can't be transmitted. You could hold HIV infected blood in your hand, with intact skin, and it wouldn't be transmitted.
John Lee Love was an African-American carpenter in Fall River, Massachusetts. He patented a Plasterer's Hawk in 1895. This was a tool used to spread plaster or mortar.
They are a weed. They will come back each year if not killed. We used to pull them, root intact, and dry them in the sun before they go to seed and spread further. They are not a 'friend' to farmland.
We use a 4 inch grinder with a diamond blade and grind out the masonry joints surrounding the block. Use a hammer to remove the block by striking the hollow cores. Once the block is removed spread mortar on the all sides surfaces of the hole (top will only be able to be smeared). Grab your new block and spread mortar on both sides and the top. Place your trowel on the underside of the block to help guide back into the hole. Tuck point and strike your joints and you are done.
Pretty much. Loose pieces, and fragments that broke off during the sinking has probably spread quite wide. But most of the ship ended up almost intact in one spot.