No. Series circuit has 1 path to flow.
It is a series circuit, where all the lamps (for instance) is on the same wire. If one lamp fails, the rest lamps will also go out.
It is a series circuit. In a series circuit, the components are connected in a single path so if one lamp is removed, the circuit is broken and the other lamp will not receive electricity.
If lamp C burns out in a circuit where lamps A and B are connected in series with lamp C, then both lamps A and B will also go out. This is because the circuit is incomplete when lamp C fails, preventing current from flowing through lamps A and B. In a parallel circuit, however, if lamp C burns out, lamps A and B would remain lit as they have alternative paths for current. The specific behavior depends on how the lamps are connected in the circuit.
no because when you remove the lamp the circuit is still open; even if the switch is on
In a series circuit there is only one path for current to flow. The current will flow through each good lamp. If any lamp opens (blows), then the circuit is broken and current flow stops. The older strings of Christmas tree lights used to be connected in series and it was hard to fine the blown bulb. If there were two burnt out bulbs almost impossible to find.
A lamp A fan and a bunch of other thingsAnswerThe classic example of a series circuit is a string of Christmas-tree lights. They are connected in series if, when one lamp burns out, all the lights go out.
A series circuit is a simple circuit, a circuit that simply goes round in a loop without any branches off. Often, these circuits have just a battery, an appliance and a switch. A lamp is an example of one of these.
In a parallel circuit, Voltage is constant through out the circuit. Thus, the voltage across each lamp is 6-volts.
The voltage drop across each lamp would decrease as you add more lamps to a series circuit. This is because the total voltage in the circuit is divided evenly among the lamps, so each lamp receives less voltage as more are added.
In a series circuit, if one lamp burns out, it breaks the circuit, causing all the lamps to go out. This occurs because the current can no longer flow through the circuit due to the interruption. As a result, none of the other lamps will light up until the burnt-out lamp is replaced or the circuit is otherwise repaired.
The lamps are wired in series.
In a series circuit, the total resistance is the sum of the individual resistances. So, the total resistance of the 3.0 lamp and 6.0 lamp connected in series would be 3.0 + 6.0 = 9.0 ohms.