answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: If 3000 ft3 of air is crossing an evaporator coil and is cooled from 75 degree Fahrenheit to 55 degree Fahrenheit what would be the volume of air in ft3 exiting the evaporator coil?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Physics
Related questions

If 3000 ft3 of air is crossing an evaporator coil and is cooled from 75°F to 55°F, what would be the volume of air, in ft3, exiting the evaporator coil?

hoi


How does an evaporator work?

an evaporator is a part of a refrigeration plant by which the refrigerant is made to boil at a much lower temperature and pressure. the idea is to extract the heat from the region which we want to cool. basically the evaporator is located at the region where the thing to be cooled is situated.


What is operating temp of air cooled motorcycle engine?

230 degrees Fahrenheit


Do you have to remove the dash to replace the evaporator on 1996 Milinea Evacuated and recharged system and it cooled for less than 24 hours Supposedly it has a leak in the evaporator?

yup. however, there are some very good stop leak additives out there.


How does nitrogen change into liquid nitrogen?

It has to be cooled to below -196 degrees Celsius or -321 degrees Fahrenheit.


What is sub-cooled liquid?

LIQUID COOLER THAN THE CONDENSING SATURATION TEMPERATURE (125 degree Fahrenheit ) IS CALLED SUBCOOLED LIQUID


Function of evaporator condenser expansion valve and condenser?

Condesor- cools the liquid formed gas after compressor compresses. After condensor it pass through the expansion valve, then again liquid formed gas expanses to gas form and produses cooling .this cooled gas then passes through the evaporator coils


What is chiller approach temperature?

Evaporator Approach is the difference between the evaporating refrigerant temperature - measured at the well in the evaporator -and leaving chilled water temperature.Take all readings with the water cooled chiller at full load.Condenser Approach is the difference between the liquid refrigerant temperature - as measured on the liquid line - and leaving condenser water temperature.


What is a chiller approach temperature?

Evaporator Approach is the difference between the evaporating refrigerant temperature - measured at the well in the evaporator -and leaving chilled water temperature.Take all readings with the water cooled chiller at full load.Condenser Approach is the difference between the liquid refrigerant temperature - as measured on the liquid line - and leaving condenser water temperature.


How many btu's of heat are removed per hour when the water at a flow rate of 10 pounds per minute is cooled 15 degrees Fahrenheit?

74,970


How does your cars ac works?

Your A/C consists of a COMPRESSOR, CONDENSER, EXPENSION VALVE and EVAPORATOR. Refrigerant (R12, or now-a-days R134a) is compressed in the compressor and turns into a hot gas. It ios than sent to the condenser. In the condenser, the hot gas is cooled until it is turned into a liquid. Then, it travels to the expansion valve. As the Refrigerant goes through the expansion valve it turns to a low-pressure gas and RAPIDLY cools in the evaporator. A fan sits behind the evaporator and blows the air around it and that eventually blows the air out your vents!!!


What does the evaporator do in a refrigeration system?

An evaporator in a refrigeration system works by passingwarm air over it's coils. The warmth of the air heats theliquid refrigerant inside, causing it to boil into gas. Atthe same time, the air looses it's heat and turns cold.