0
What else can I help you with?
If ECP mode does not work on your parallel port what should you do next?
· Recall the ECP uses a DMA channel. Allow setup to keep DMA3 unless you suspect a conflict with another device trying to use DMA
What switch port modes will allow a switch to successfully form a trunking link if the neighboring switch port is in dynamic desirable mode?
since the first desire of desirable mode is to trunk,so the switch port mode will be trunking since the first desire of desirable mode is to trunk,so the switch port mode will be trunking
What is bsr mode?
this mode is related to only port c.the bits of port c can be controlled directly by the microcontroller
Identifier must be declared with a port mode?
In VHDL, an identifier used to define a port in an entity must be associated with a specific port mode, which indicates how the port will be used. The three primary port modes are in, out, and inout. Specifying a port mode is essential as it defines the direction of data flow: in for input signals, out for output signals, and inout for bidirectional signals. Without declaring a port mode, the VHDL compiler will raise an error, as it cannot determine how to handle the signals connected to that port.
Where is the diagnostic port located on a 2005 Nissan Altima?
The diagnostic port on that car should be next to or in the fuse box panel
What is port and harbor engineering?
a word port can used for any place where goods and passenger are transfered from waterborn mode to landborn mode .
When might you need to disable ECP mode for parallel port?
An occasion when you need to disable the ECP mode for parallel port is when resource conflicts occur. In such a case, the EPP mode is the better option.
How do you find Xor in kotor?
after to talking him the first time then go to you should meet him on the next port
What should you do after you have saved port royal 2 times on Kingdom Hearts II?
You proceed to the next world.
When port security is enabled a switch port uses the default violation mode of until specifically configured to use a different violation mode?
Yes, By default port security is disabled on a Cisco switch. If it is enabled the default violation mode is shutdown with a maximum MAC address count of 1. Even if port-security is enabled it will not place a port into the shutdown state until either MAC address sticky or a static MAC address is configured on the port.
When might you need to disable ECP mode for a parallel port?
# If you are having problems with resource conflicts, you could try disabling ECP mode for the parallel port. EPP mode gives good results and does not tie up a DMA channel.
When port security is used on a switch which violation mode will cause an snmp trap to be sent and traffic to be dropped when the number of secure MAC address for a port is reached?
Port security is used on a switch and the number of secure MAC addresses for a port is reached, the violation mode that will typically cause an SNMP trap to be sent and traffic to be dropped is the "Shutdown" or "Protect" violation mode.
