answersLogoWhite

0

If you grind the welding cup then you perform ferrite number measuremnt on previous run which has been tempered by its consequent run and thus it has higher ferrite number. Please have a look at this link: http://www.weldinguide.com/gdanastasiadis/viewtopic.php?f=14&t=484

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

What is the basic Difference between ferrite core and normal transformer?

i think Transformer operates AC and ferrite core operates in DC


What is the difference between pearlite and ferrite?

Pearlite is a layered structure of ferrite and cementite formed by the eutectoid reaction in steel, while ferrite is a pure form of iron in its BCC crystal structure. Ferrite is soft and ductile, while pearlite is harder due to the presence of cementite.


Why does a voip phone require a ferrite clamp?

Ferrite


What is ferrite number?

Ferrite number is a measure of = Chromium & Nickel equivalent in an Austenitic stainless steel material. It should be between 3-7% max. Very low ferrite can lead to cracks. It is a measure of denoting the ferrite content in an stainless steel. Ferrite Number has been adopted as a relative measure for quantifying ferritic content using standardized magnetic techniques. The Ferrite Number approach was developed in order to reduce the large variation in ferrite levels determined on a given specimen when measured using different techniques in different labratories.The ferrite level is only important to assure minimum exposure to solidification cracking when depositing austenitic stainless steel weld metal. The lower ferrite number is better for corrosion resistance, while balancing higher ferrite content to avoid solidification cracking in the weld deposit. I would not worry about lower ferrite numbers for clad overlay welding, if no cracking is observed (Liquid Penetrant verification).


How do I convert a Ferrite number into a percentage?

While there is no direct correlation, with higher ferrite numbers ( >30) a factor of 0.7 can be applied to produce % ferrite.


Which is more soft phase ferrite or austenite in iron carbon diagram?

Pretty sure it is ferrite


When was Zanoni Ferrite born?

Zanoni Ferrite was born in 1946, in So Paulo, SP, Brazil.


How to measure the ferrite number?

You can measure the ferrite number of a steel using a Severn Gage, a mechanical device; or using a ferrite scope, an electronic device, available from several manufacturers.


Details about ferrite core inductor?

Ferrite core inductors are made for higher frequencies. The ferrite core is a non-conductive ferri-magnetic material which prevents eddy currents from flowing through it. The ferrite formulation is xxFe2O4 with the xx representing various types of metals.


How to use a ferrite core?

Ferrite cores are used to suppress electrical noise on conductors. A split ferrite is installed over a conductor as close to the source of noise as possible. A solid ferrite has the conductor routed through it, it may also have several turns of the conductor looped through the donut shaped ferrite. Take a look at a motherboard and you'll see ferrites in use in the power supplies.


What is the difference between ferrite bead and an inductor and On what basis they have to be selected?

Ferrite bead is a lossy inductor.When the frequency is high the Ferrite bead purely acts as a resistance so high speed noises are absorbed by the FB and it dissipate in the form of heat. Based on the current rating,cross over frequency the ferrite bead should be select ANSWER: A ferrite bead is a powder core if a line is wrapped on it that will eliminate RF signal externally injected into the line to interfere with the circuit that the line is going to it. The selection is arbitrary until it does the job. bigger the better. An inductor is also a choke to reduce RF but not as effective and it does have losses on the line


Is ferrite is a metal oxide?

No