answersLogoWhite

0

If you have the 1.6 Liter SOHC engine the answer is YES. This is an Interference engine, and if the belt breaks engine damage will occur. Belt should be replaced every 30,000 miles. I know that sounds absurd, but that is the factory recommendation. If you have the 1.8 Liter DOHC engine, no damage will occur. It is NOT an interference engine. Replace the belt every 60,000 miles.

If you have the 1.6 Liter SOHC engine the answer is YES. This is an Interference engine, and if the belt breaks engine damage will occur. Belt should be replaced every 30,000 miles. I know that sounds absurd, but that is the factory recommendation. If you have the 1.8 Liter DOHC engine, no damage will occur. It is NOT an interference engine. Replace the belt every 60,000 miles.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

Why engine doesn't run after changing timing belt and water pump engine has spark and fuel 1990 geo storm gsi?

Did it run before?


Business that repairs storm-damaged roofs?

John Peters Roofing is known to repair storm-damaged roofs.


How do you set the timing on a 92 geo storm DOHC 1.6v?

To set the timing on a 1992 Geo Storm DOHC 1.6L engine, first ensure the engine is at top dead center (TDC) on the compression stroke for cylinder one. Then, align the timing marks on the crankshaft and camshaft pulleys according to the specifications in the service manual. Use a timing light connected to the number one cylinder to check the timing against the recommended specifications, and if necessary, adjust by loosening the distributor and rotating it until the timing is correct. Finally, retighten the distributor and recheck the timing to ensure it remains in the correct position.


What are timing marks for a 1991 geo storm gsi dohc?

The timing marks for a 1991 Geo Storm GSI DOHC are typically located on the crankshaft pulley and the timing belt cover. The marks should align when the engine is at top dead center (TDC) on the compression stroke. It is important to consult the vehicle's service manual for specific instructions on locating and aligning the timing marks correctly.


How many trees were damaged if a storm damaged 12 percent of 6250 trees?

750 trees were damaged.


Where is the alternator belt located on a 1992 geo storm?

the alternator and belt are located at the bottom of the engine on the passenger side looking at the timing belt side


Is the 1991 geo storm a non interference motor?

The 1991 geo storm is not classified as a non-interference motor. Instead, it features an interference engine design, meaning that if the timing belt fails, the pistons can collide with the valves, potentially causing significant engine damage. It's important for owners to maintain the timing belt and replace it according to the manufacturer’s recommended schedule to avoid such issues.


Would the space station be damaged in a large solar storm?

If it was struck, it could certainly be damaged.


What is the timing on a 1990 geo storm?

Answer: The ignition timing on a 1990 Geo Storm is 10 degrees BTDC. This applies to both the SOHC and DOHC 1.6L engines.


What is the complete verb of this sentence. The entire shoreline had been damaged by a sudden and violent storm?

Had been damaged.


Where the verb the entire shoreline had been damaged by a sudden and violent storm?

had been damaged is the verb phrase.


Is the 1993 Geo Storm engine an interference motor or are you OK if the timing belt breaks?

the clutch is really easy to install and the timing belt is not a problem if its shot The 1993 Geo Storm is not an interference motor, because my belt just broke,(Nov 2005) and I got the same question answered on the following website: "www.nutzandboltz.org". My daughter's 1990 Geo Storm timing belt broke while she was driving it. She tried to start the engine but it would not run. We were told that it was an interference motor and that the motor was now shot. Being a little skeptical of the "experts" I put a new timing belt on and the engine started and has run fine for several months (clutch just went out). So much for the experts, by the way how ard is it to change the clutch? Thanks M in Omaha