Yes, but it will not pass a code inspection and is unsafe.
No. Hook up the power wire first, then the ground wire. The ground wire is what acutually draws the power to the unit. As you will notice the power wont turn on if just the power wire is plugged in..
Connect the ground wire to the metal box.
two problems i had .....on the back of the head unit ...the brown wire is the park break wire ground that wire and thats it ...also the orange wire is not the ilumination wire its for camera i diddnt see that ,,,,dont hook up that wire if you dont have cam .
to hook up the tach use the hot lead on the disributor and to any good ground wire and if there is a light hook it to the wire on you light switch
One wire goes to the sending unit in the tank. It should hook to a terminal beside where the fuel line connects. The other one grounds out the body of the sending unit or the whole plate where the fuel line goes into the tank. 3-4 inch round plate. The ground wire will either go into the wire harness with the sending unit one or ground directly to the frame. The ground wire on all gas tanks very often rusts off.
My gas guage is moving irraticly I think it's a ground wire. which wire is the ground? I dont have a multi meter
on my older jvc its no problem at all just ground the wire that your radio says to hook up to the ebrake. newer ones and like my pioneer need to have the radio turned on first then ground that wire. trick is --- get a standard universal relay--- like from autozone for your aftermarket driving/fog lights. take the 85 terminal of your relay and hook it to your radios power amplifier wire(usually blue with white stripe), take the 86 terminal and hook it to ground. take the 87 terminal and hook to the same ground, and finally take the 30 terminal and hook it to you radios ebrake wire. simple :-)
hook the ground wire to a good ground and pierce the wire you want to check with the tester, if it lights up, it has power, if not it doesnt.
Ground unit to inner fender well or other good engine ground Run an ignition sensitive Hot wire to unit
There should be a black ground wire in the Chevy Celebrity radio wiring harness. If for whatever reason that is not available then simply hook a wire from the metal shell of the radio to a convenient point on the dashboard near the radio. I would use a convenient bolt or screw if at all possible.
black and red wires are hot,blk wire to wire junction and brn t/lamp wire cut in,red to batt pwr,blk/w wire to ign turn on and ground to ground..
Un hook the wire going to it , and ground it with the key on and it should go all the way over to highest point. If it does that means the gauge is good. Replace oil sending unit. You can also screew a gauge in its place and read oil preesure. ( remove oil sending unit)