Science
Men's Health
Public Health and Safety

If you have an erection and put it into a box of mosquitoes will it turn flaccid?

123

Top Answer
User Avatar
Wiki User
Answered
2013-03-08 21:38:21
2013-03-08 21:38:21

Yes, your penis would turn flaccid because a man's erect penis is mostly blood.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


there is a box that read the box and it will say turn gear and do that and it will turn


Find your way to the top left side of the map. Turn south push the box once. Turn west, push the box twice. Go north 2 squares, turn west push the box twice. Don't worry about the prize box on top because it's just 1000(money). Turn south, push the box 3 times. Walk your way down to the box that's further south. NOT the one you just pushed. Now you are face east. push the box to the east once. Turn south walk 4 squares, Turn left, push the box once.Go back up to the box you just pushed. Turn north, push the box upward once. Turn east walk up to the box and push it twice. (The prize box "a star" on the right would be blocked 2, but the target of this maze is to get the rock n roller item.) Turn south and walk down. Turn west, push the box once. Turn south walk 2 squares and turn west. Push the box 3 times. Turn north and you should know your way... Hope this helps.


First, turn the smallest box into a ball so it will land underneath the wood thing. Then, turn the red box into a ball. Lastly, turn the biggest box into a ball and it will knock the red ball off.




Use the power button that is on the converter box.


to clone Pokemon you deposite Pokemon into a empty box then change your box to another empty one but when it says 'saving don't turn off the power' turn it off then turn it on then the Pokemon you cloned will be in the box and in your party. hope this works for you it did for me


There is a switch in the glove box to turn it off.


Some of the steps that are in rumba are left box turn and the under arm turn


How do I turn enable bidirectional support on in the Canon MG2100 series properties dialg box


inside the glovebox there are two white tabs turn them and the fuse box will drop down inside the glovebox there are two white tabs turn them and the fuse box will drop down


you go to bill's PC, deposit a Pokemon there, then you change the box to box 2, when it is saying saving turn it off, then turn it on again you will have the Pokemon with you and in the PC.


How do youProgram digital converter box when it won’t turn on to put the code in for the remote


Turn off the fuse in your fuse box which that electrical outlet is connected to.


the turn singal flasher is on the pass side by the heater box.


In the fuse box. They are often labeled.


Use a cereal box or a shoe box and create a scene from the book inside of it. It should turn out pretty Amazing!


in the steering colume there is a little box connected to turn signal you replace that little box but you have to take lower colume off.


Fuse box is in glove compartment left side, Fuse box is marked,the one for turn signals is marked "TAIL"


The turn signal flasher on a 1986 Honda Civic is located on the cabin fuse box. It will be plugged into the fuse box and its backside.


The Turn signal Fuse should be number 11 (7.5Amp) in the fuse box. Hazard Lights are on number 14 (15Amp).


most e250 turn sig. flasher are located on fuse box (under dash) small metal box


You can turn on magnavox converter boxes without remotes by going to the central control box and then pressing the reset button to accomodate the power button.


Some general reasons a cable box won't turn on can include:The cable company is doing maintenance.The box's serial number is not registered with the cable company.The account holder was late paying the bill.The power cord has become detached from the outlet; it is not plugged in.The remote being used to turn on the box needs a new battery; replace and try again.The box needs rebooted. Some boxes have a memory which needs cleared.The best troubleshooting is to detach all cords from the box and turn off the TV.Plug the box back in and reattach it to the television.Turn the box and TV back on.Let the box reboot.If it works, your problem is solved.If it does not work, call the cable company.


In bejeweled Menu dialogue box is the sound control to turn sounds on or off



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.