Want this question answered?
Turn off the engine, get out of the boat and assess the damage, then call your insurance agent. If you don't have insurance, then just get out of the boat and pull it back home.
Make sure no one is injured and then checks for no leaks.
You should let the ventilation system run about four minutes before starting the engine on a boat.
Run the ventilation blower for a minute after fueling.
Switch off the engine.
A rubber band boat works much like a rubber band airplane. First you need to build the boat itself. Then you need to make a propeller. The propeller shaft needs to run through the inside of the boat, not below the boat. With the prop below the water. The propeller shaft should not go the full length of the boat. About halfway through put a loop in the shaft. Then to the front of the boat attach a rubber band. Then run the rubber band through the loop in propeller shaft. Now twist the prop and the rubber band should twist around and around. When it's good and tight let go and the propeller should spin. Allowing the boat to move forward in the water. Mind you the shaft needs to be a thin piece of metal, as it will be difficult to make it water tight.
Calmly assess the situation and get everyone to don PFDs
Adam, easily done as they were nude in the garden of eden. nice answer
If your boat runs aground, check the safety of passengers, then check for leaks.
Try to shove off with a paddle or boathook.
Because we can run house boat only in water
no its still water but let it run a couple minutes first