0
What else can I help you with?
Why 1991 explorer blower wont work on high?
Either the switch or resister network has failed and needs to be replaced.
How do you fix a brake on off switch in a 1994 ford explorer?
The switch isn't repairable and should be replaced if bad. It's located on the bar where the brake pedal is attached.
Why would an AC fan work only on high?
The fan switch is probably bad. My Ford Explorer did that, I had to have the switch replaced. This could also be caused by a bad blower motor resistor.
Your car cranks sometimes starts sometines doesnt could this be a transmission problem?
THE netural Saftey Switch could B bad .
1992 4x4 explorer your cruse control will turn on but when you hit the brake to dis engage it it doesnt turn off whats the problem?
bad brake light switch
How does turtwig evolve?
put him in first then switch him out so he doesnt get hurt put him in first then switch him out so he doesnt get hurt put him in first then switch him out so he doesnt get hurt
If your AC works fine then stops and later starts working fine again and the system is full is there some switch that needs to be replaced?
sounds like the high pressure switch ase in air!!!!!!!
Why wont explorer wont crank over. i have replaced the starter ignition solenoid and switch as well as the neutral switch but it still wont start or crank over when i turn the key. any solutions?
Check your ingnition cylinder ...
Ford explorer sport trac third brake light works but others dont work?
I have the same problem - but my third brake light slightly flashes when the car is of (Explorer 1998). I have replaced the "stop light" switch with no improvement at all.
How do you remove ignition switch from 1992 Ford Explorer?
Type your answer here... How do you remove ignition switch from 1992 ford explorer?
How do you replace a head light switch 93 ford explorer?
replace head light switch on 93 ford explorer
What is a clutch triple function switch on an explorer?
The Ford Explorer triple function clutch switch is located on the top of the transmission. The switch should be labeled for easy identification.
