answersLogoWhite

0

See below

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Will a starter from a 1998 explorer fit a 98 expedition?

no it wont fit.


What causes a clicking sound when you try to start a 98 blazer?

starter part were the wires are.


How do you change the starter of a 98 Ford Contour SE?

The starter on a 98 Ford Contour SE is changed by disconnecting the battery, jacking the vehicle up, and removing the starter shield. The retaining bolts and bracket can then be removed, the wires disconnected, and the starter removed.


Not getting fire to sparkplugs on 98 ford expedition 4.6lt?

Check your spark plug wires. They maybe bad.


Why won't my 98 4 runner start I turn the key and there is a loud clickinglights work engine is not turning over?

It sounds like the solenoid is working but the starter is not. Check the wires on the starter. Possibly the starter has gone bad.


Do you have the starter schematics for a 1998 softail?

do you have the schematics for a '98 softail starter?? do you have the schematics for a '98 softail starter??


98 Toyota Camry Starter replacement?

98 Toyota Camry Starter Installation


Where is starter solenoid 98 Expedition?

In a 1998 Ford Expedition, the starter solenoid is typically mounted on the starter motor itself, which is located on the passenger side of the engine, near the bottom of the engine block. You may need to lift the vehicle to access it easily. The solenoid is usually a cylindrical component attached to the starter with electrical connections. Be sure to disconnect the battery before attempting any repairs or inspections.


A diagram for a starter for a 98 Ford Contour?

i need diagram for a starter a 98 ford contour


Where is the starter located on a 3.5 rl acura 98?

does anyone know where a starter is located on a 98 acura 3.5 RL


Show you how to replace ignition coils for a ford Expedition 2003?

98 expedition


98 Expedition running rough you replaced the plugs wires and it ran smoothly for a while but missing again Does anybody know where you should look next Coils?

distributor cap and rotor