Sh*t blows up.
what happens if we remove Rc in RC coupled amplifier
non-magnetic :)
The gain increases.
It's no longer magnetic
most capacitors will measure infinite resistancestarting capacitors are used to set up a rotating magnetic field by phase shifting a coil in a single phase motorwhen the motor gets up to speed a centrifugal switch will disconnect the capacitorthis happens at a random time and can leave the capacitor with a charge easily 4x the applied ac voltage (+/-1,000V)so some capacitors rated as starting capacitors will have an internal bleeding resistorGas discharge lamp ballast capacitors sometimes have discharge resistors.Microwave ovens have capacitors usually in a voltage doubling configuration(+/-20,000V) most have an internal bleeding resistor.Never rely on this resistor being intact or even present.It can have fatal consequences.the internal resistors are sized to discharge the capacitors in tens of minutesTc = R * C ( seconds = ohms * farads )
As the DC component in the signals are not required to be amplified, rather not required at times. Thus a blocking capacitor blocks this DC component from.entering the amplifier. Bypass capacitors are used at the emitter end so that the AC signal reaching the emitter end does not alter the biasing required to maintain the Q-point. All the above happens using the basic characteristic of a capacitor, that it blocks DC and passes AC.
they combine and become one magnetic field
It remains constant
It remains constant
The total capacitance from capacitors that are connected in series are added up inversely; 1/Ctotal = 1/C1 + 1/C2 + ... + 1/Cn, where Cn is the capacitance of the nth capacitor.
It happens due to magnetic activity.
There is nothing -_-