It is the Network access service
NAS IP is the IP address of a switch or another type of a radius client. NAS Port is a little harder to explain, but it is a number that is assigned to the interface authenticating and edge device. Similar to the NAS PORT ID, but not static.
A full numeric IP address with port number is XX.XX.XX.XX:PPPP where the "X"s are the IP address and the "P"s are the port number.
what is the ip address for facebook with port 6555
No, each computer must have a different IP address. The IP addresses have to be in the same subnet between themselves, and in the same subnet as the ADSL router (or modem); I won't explain subnets here, but usually having the same numbers for the first 3 parts of the IP address is enough. For example, if the ADSL router has the IP address 10.0.0.1, your computers might have addresses 10.0.0.2 and 10.0.0.3. If you need to add a third computer, give it the IP address 10.0.0.4If the first computer has a different IP address - and it works - replace that, instead. For example, if the computer has IP address 172.16.0.2, assign the address 172.16.0.3 to the next computer.
If you are looking for an example of a IP address then a port number, here is one:192.168.0.1:2712192.168.0.1 is your IP address and the : means a port number so :2712 is the port number.This also works on websites. For example: wiki.answers.com:2712Together, the combination of an IP address and a port number is called a socket.
Yes. Routers normally have more than one IP address.
The Cisco switches I have seen don't have an IP address by default. You have to connect to the switch with a console cable - one that connects to the console port on the switch, and to the serial port on the computer - and do some initial configuration, including the IP address.The Cisco switches I have seen don't have an IP address by default. You have to connect to the switch with a console cable - one that connects to the console port on the switch, and to the serial port on the computer - and do some initial configuration, including the IP address.The Cisco switches I have seen don't have an IP address by default. You have to connect to the switch with a console cable - one that connects to the console port on the switch, and to the serial port on the computer - and do some initial configuration, including the IP address.The Cisco switches I have seen don't have an IP address by default. You have to connect to the switch with a console cable - one that connects to the console port on the switch, and to the serial port on the computer - and do some initial configuration, including the IP address.
Information used are the source port number, the destination port number and ip addresses.
Without any more information, you would put the internal IP address of the Linksys router. But, depending upon what you are trying to accomplish, you might need to port forward from the Linksys to your new device if, for example, you needed to access it from outside your network.
Source port numbers
It is true that a socket address comprises the IP address of the host and a port number.
First you have to configure your NIC card, preferably with a static IP address. Then, tell the webserver software which port and which address to listen on.