answersLogoWhite

0

An iron or steel with wire wound on it turns the drive shaft.

User Avatar

Francesca Feil

Lvl 10
3y ago

What else can I help you with?

Related Questions

In an electromagnet what turns the drive shaft that does the work?

An iron or steel with wire wound on it turns the drive shaft.


What turns the drive shaft that does the work?

The engine turns the transmission then the transmission turns the driveshaft.


In an electromagnet that turns the drive shaft which does the work?

The driveshaft carries the power but the whole unit does the work.


In an electromagnet which turns the drive shaft that does the work?

The driveshaft carries the power but the whole unit does the work.


What in an electromagnet the what turns the drive shaft which does the work?

In an electromagnet, the magnetic field produced by the flow of electric current through a coiled wire interacts with the permanent magnet on the drive shaft, causing it to rotate. This rotational motion of the drive shaft is what is responsible for performing work in devices like motors or generators.


How does a shaft drive motorcycle work?

go to this address and you can see a animation of how a shaft drive works. this is one on a bicycle but the only difference is a motorbikes is larger and its a engine powering it instead of pedals. the engine turns 1 cog which turns a pole which inturn rotates a 2nd cog which is attached to the rear wheel giving you forward motion. http://www.dynamicbicycles.com/Animation/dynamicpopup.html


How does the steering wheel work?

turns a shaft connect to steering gear box, which then turns wheels through different ways


How does a shaft drive work?

It works with gears on both ends of a shaft in stead of a chain. If you have two wheels and they both have gears just like a chain drive but replace the chain with a single shaft that also has gears on each end, you will understand how a shaft drive works.


My 1988 Bronco2 had a little clicking noise in the front leftnow the 4 Wheel drive quit working drive shaft turns but the 4 Wheel drive does not work whats the problem?

A friend of mine had the same problem and he just had to jump out and lock the hubs manually to get his 4x4 working.


How does the drive line work?

One end of the driveline is coupled to the end of the transmission's input shaft, which 'drives' the line. The other end of the driveline is coupled to your rear end's center section, which turns your rear wheels.


How do you get a 78 4 whell drive into 2 wheal drive?

you have to get a tranny from a two wheel drive and drive shaft. remove everything to do with four wheel drive and hook up the new tranny crossmembere and drive shaft then it will work. if you want to do the front end good luck


How does the front end work on a 4 wheel drive 2000 Jeep Cherokee without manual lock-outs?

the wheels ar always linked to the axle and the drive shaft the drive shaft is disconnected in the transfer case