answersLogoWhite

0

Yes , its a quasi equilibrium process so heat is added slowly

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Does heating your car burn gas?

Usually heating is done by passing air over the hot engine so no extra fuel (gas/petrol) is used.


Has anybody done an engine swap on a Celebrity for a 305?

Most likely not, and with good reason as it couldn't be done without extremely extensive (and expensive) modification.


What if you put a jet engine in a car?

It has been done. The car is slow to take off but extremely fast once it gets going.


Comparison between internal combustion engines and external combustion engines?

Internal engine has its energy ignited in the cylinder. like 99.9% of engines today An external combustion example is a steam engine where the heating prosses is done in an boiler out side the engine.


What is adiabatic heating?

Heating that results from work done on the system, such as when a gas is compressed within a piston.


How can you separate the water from the salt of crystallisation?

This can be done by heating the salt.


How long pre-heating should be done?

Depends upon the oven you use (if gas or electric) but normally pre heating must be done until the desired temperature is already achieved.


How long pre heating should be done?

Depends upon the oven you use (if gas or electric) but normally pre heating must be done until the desired temperature is already achieved.


You are repairing a house that has no heating or cooling ductworkWhat can be done to provide cooling and heating?

Use baseboard heaters and an air conditioner.


What would cause the engine of a 1990 Nissan 300ZX to shake after you start it then eventually die?

If a tune up was done recently then the spark plugs and the wires are hooked up wrong. If not then the engine could be out of time, or be extremely low on fluids. Good luck.


Why the saying you have done what Napoleon could not do?

You have done what great men cannot do before subordinates


The amount of work done by heat engine equals the amount of what?

The amount of work done by a heat engine equals the difference between the heat input and the heat output of the engine. This is known as the heat engine's thermal efficiency.