Heat rises. So, in areas with long winters, the vents typically are in the floor. But it depends on the construction of the house, where the heating unit is installed and what type it is, etc. So, no easy answer. Ceiling fans are helpful in keeping air circulating, moving warmer air from the top of the room downward which helps even out the temps from floor to ceiling.
It would be better to place the heating vent near the floor because the heat will travel up and down, so that way the room would be heated evenly. If you place it near the ceiling, the heat would not heat the floor that well, since the heating vent sucks back in the heat
To save on heating costs
Heating vents should be placed near or on the floor in a room because heat travels up not down.
It could be caused by a damaged heating element. You should have the heating element checked by a professional. Try cleaning the dryer first. Remove lint clogging the exhaust vent. Overheating in the washer might cause the heating element to shut off safely. Also check if the dryer is plugged correctly.
There are a number of causes as to why a hot water heater would stop heating the water. It could be due to a fault in the circuit breaker or a problem with the element, limit switch or thermostat. Unless you know what you are doing, you should contact a qualified plumber or electrician to rectify the issue.
It would be better to place the heating vent near the floor because the heat will travel up and down, so that way the room would be heated evenly. If you place it near the ceiling, the heat would not heat the floor that well, since the heating vent sucks back in the heat
before
It is not necessary to be especially careful when heating sodium chloride.
Because there is no reason for them to be evenly separated. You're starting with the assumption that they SHOULD be evenly separated, and looking for a reason why they end up being something other than they should be. Your assumption is faulty. And so your question is meaningless.
Yes,you can call your local heating provider to fix your heating. This is a nice and cheap way to use a local provider to fix the heating systems in homes.
what is the first test that should be made on a heating electric appliance
The answer depends on the thermostat setting as well as the kind of heating system that you have.
of course why to be partial..
Heating should do it
To save on heating costs
in the floor.
Positive temperature coefficient heating element. Resistivity grow larger with higher temperatures so the heating element should be self regulating.