electric panel
No, it shouldn't. Electrical work revolves around recommended and non recommended procedures. In this case, the sheathing needs to project no more than about one inch into the electrical panel.
Electrical wire sheathing should not project more than about one inch into the electric panel.
The electric panel is something into which electrical wire sheathing shouldn't project more than about an inch. There are recommended guidelines, and non recommended actions, in electrical work. This is such a case, of recommended actions regarding sheathings and panels.
plumbing line floor joist electric panel ground Electrical wire sheathing should not project more than about one inch into any device that uses a cable clamp to secure the cable to the device.
Electrical wire sheathing should not project by more than one inch into where the wire terminates into a specific device. An example is a junction box or branch circuits terminating into a distribution panel.
B. Electrical panel
6 inch
One inch.
.0011 1/2 of an inch
Electric wire sheathing should not project more than one inch into the electric panel.
Its is used in fabrication and installation in EPC project
Electric Panel ---------------------------- Based on the answers you have proposed, Electric Panel is the correct choice. However, I do not know of any requirement in the NEC that prohibits the sheathing from extending further into the panel. There is a requirement that it must extend through the connector, but I know of no NEC requirement on when it must stop. --Sparkfighter