No, 122 volts for a house is not high. It is a nominal figure in the same 120 voltage range. It is brought about by the power company, as they have a responsibility to keep voltages within a certain 10% range. The load will only notice a difference of 1% on the load current. e.g. Wattage load of 2400. Amps = watts/volts. 2400/240V = 10 amps. 2400/220V = 10.9 amps. On a constant resistance as the voltage goes lower, the current goes higher and vice versa as the voltage goes higher, the current goes lower.
Depends on the country
The Mississippi House of Representatives includes 122 members. The Mississippi State Senate includes 52 members.
120 volts and 240 volts. Typically 240 volts is supplied to the house electrical service entrance. It is split into it's 120 volt components via two buss bars. Hooking a circuit up to just one bar yields 120 volts. Hooking into both gives 240 volts.
50- 7000
600 volts
The voltage in North America can be as low as 110 and as high as 125 volts. The average is about 115 to 117 volts. <><><>><> House voltage in the US is generally 120v line to neutral and 240v line to line. It is referred to as a "120/240v single phase service." Actual voltage can be as low as 110/220 or as high as 125/250.
Downstream O2 sensor circuit volts high.Downstream O2 sensor circuit volts high.
route 122 (in the high floors[ in the cave])
Chronic Lymphocytic Leukemia
220 volts, 110 volts, 440 volts, 400 volts, AC or DC voltage. High voltage like - 220 KV, 400 KV, etc
No. 240 Volts was the nominal standard in Australia with a tolerance of +/- 10%, So the voltage could be anywhere between 216 Volts and 264 Volts. The change to 230 volts is part of international harmonisation between countries that use 220 volt standards and 240 volt Standards. The new tolerance levels are +10% and - 6%.
yes, 126 is a little high.. 1 or 2 volts ok