Yes, as long as the "front end" doesn't weigh more than 2 tons.
Sure, it can be done.
That requires a front end alignment machine to do that.
To lift the front of a Ram you have to replace the springs, or add spring spacers.
Howard Brothers Discount Stores ended in 1986.
in a pick up it will if it is 4X4 you need to make sure the gear is the same as in the front end
In most cases yes as you were not following at a safe distance.
Yes all you need are the normal headphone jacks on one end and speaker jacks on the other end.
Assuming that you are a safe driver, the long front end of a Nissan Rogue should in no way hinder your driving.
This depends entirely on what make model and year the machine is as well as why it is being driven. It is not safe to use it as a loader with the prop shaft missing, but it might be if it is just being moved.
How about a audio cable with two MALE RCA jacks on each end. If both units are not stereo, use a "Y" cord to convert stereo to mono.
The cheapest way to lower the front end would be to install Eibach springs. They usually run about $250 for the front/rear set. You can't buy just the front set, but you could just install the front set, although Eibach does not recommend this. For a little more money you could install front drop spindles.
It received the highest rating of good in front-end and side-impact testing by the Insurance Institute for Highway Safety.