Fuel Filters
Chevy Celebrity

Is a 1988 Chevy Celebrity fuel injected or carburated?

012

Top Answer
User Avatar
Wiki User
Answered
2012-07-23 06:48:51
2012-07-23 06:48:51

All 1988 Chevy Celebritys are fuel injected.

As information 1986 was the last year of carburated engines, it was the 2.8L V6.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


what is the wiring diagram for an 1988 Chevy celebrity stero


No, the 1988 323 is fuel injected. Are you needing to service the car? if so what needs doing? Cheers Malcolm


The starter on a 1988 Chevy Celebrity is located on the bottom of the block at the bellhousing.


The fuel filter in your 1988 Chevy Celebrity is on the driver's side behind the rear wheel next to the fuel tank.


The fuel pump on your 1988 Chevy Celebrity is in the fuel tank.


Yes it is. Anything from 1988 and up is fuel injected.


The 1988 Chevy Celebrity uses distributorless ignition. There is no provision to alter timing, the engine control module takes care of that.


It is if it's a 1988 or newer.


The fuel filter on a 1988 Chevy celebrity 2.5 litre FI is located right in front of the rear passenger side tire.


Yes late 1987 Chevrolet trucks were fuel injected same as 1988 motors.



The PCV valve on a 1987 - 1990 Chevy Celebrity is in the top center of the valve cover nearest the firewall.


The coolant fan relay on a 1988 Chevy Celebrity with 2.8L V6 is on the radiator support bracket behind the right hand headlights.


No, there is no camshaft sensor on that model.


Other than the 1987 and 1988 Eurosport VR versions I am unaware of any Chevy Celebrity with cup holders.


The firing order on all Chevy Celebrity V6's is: 1-2-3-4-5-6




The starter is on the bottom of the block on the side nearest the radiator.



Yes, the 1991 Metro was carburated. Metro's were carburated from 1988 - mid 1992. Some metros had fuel injection but those are rare nowadays.


The ignition module on a 1988 Chevy Celebrity with 2.5 engine is on the side of the block beneath the intake manifold. You can simply follow the spark plug wires to it. As information the crankshaft position sensor is behind the ignition module.


Yes, although it may not start well since carbuated vehicles need to have the choke "set" before starting the engine in the cold. To set the choke, a carburated vehicle needs the accellerator pedal pressed down once. That is not required for injected vehicles.


Does your car have the 4 cylinder engine or the V6?


2.5 L engine = 20 to 21 avg mpg



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.