0
no it is a four stroke
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
1988 Quadrunner is hard to start?
# it could be the batte or the olternater
Where is the oil filter 1988 suzuki 250 quadrunner ATV?
You need to take the passenger side wheel off, then their is a cover with three small metric nuts about 2" wide, remove them and filter slides out.
What is the oil gas mixture for a 1988 2 stroke suzuki outboard motor?
The fuel to oil ratio, for a 1988 model Suzuki outboard is 50:1, roughly 1 pint of 2 cycle oil, to six gallons of fuel.
1988 suzuki quadrunner 4x4 has spark not start New plug good gas new needle?
I had the same problem a couple of years ago turned out to be a fuel pump.if I put gas in the cylinder it would run but soon stall hope this helps.
When was Suzuki Escudo created?
Suzuki Escudo was created in 1988.
Where is the computer on a1988 Suzuki Samurai?
there is no computer on a 1988 suzuki samauri
What is the difference between a 1986 Lt250 Quadracer and a 1988 Lt250 Quadracer?
The earlier Quadracers (85-87) have plain, dark aluminum colored frame and motor. In '88 they began to paint the frame and motor the Suzuki blue. Also, the earlier models had a 5-speed transmission, while the later ones (88-92) had a 6-speed transmission. I've also heard that the earlier model years had issues with head gaskets. The later model years had an extra bolt to help with this problem. In '92 they also changed the rear suspension in the Quadracers.
When was Suzuki Sadatsugu born?
Suzuki Sadatsugu was born on January 10, 1988, in Gunma, Japan.
Is a 1988 Yamaha warrior a 2 stroke or a four stroke?
4 stroke. A Yamaha Blaster is a two stroke and so is a Yamaha Banshee but not a warrior.
What is the firing order for 1988 Suzuki Samurai?
1,3,4,2
When was Minto Suzuki born?
Minto Suzuki was born on January 19, 1988, in Mie Prefecture, Japan.
How do you adjust the front brakes on a 1988 Suzuki Quadrunner 300?
if you look on the front rims there should be wats looks like a rubber plug pull it out and take a flashlight and look in the hole and u should see a little cylinder and it will have what looks like gears on each end take a flat screw driver and turn it and there u go
