Usually it's a permanent magnet. You could use an electromagnet instead, but doing so is considerably harder from an engineering standpoint.
it farts then it poops
You would not get a true reading any longer. The forces of the electromagnet are greater than the natural magnetism of the Earth.
That's a permanent magnet. After all, the compass doesn't need an electrical current, right?That's a permanent magnet. After all, the compass doesn't need an electrical current, right?That's a permanent magnet. After all, the compass doesn't need an electrical current, right?That's a permanent magnet. After all, the compass doesn't need an electrical current, right?
Neodymium Iron Boron (NdFeB or NIB) would be the stongest material of an magnet.(Is the tempature which for this material is 12,800 . Hc is the lenth of the material which is 12,300. BHmax is the strenth which is for this material 40 . The other strenth for other materials are 26, 5.5,3.5 . The highest was 40
It is a permanent magnet. Electromagnets(as the name suggests) requires an electric source to become a magnet, when the power source is turned off it will not function as a magnet.
the compass's needle will point at the electromagnet
the arrow in the compass would point to the magnet
Get a compass
PermanentThere is no source of current in a compass, therefore the magnet is a permanent magnet.
the arrow goes to the magnet
Yes
it farts then it poops
Yes
no
You would not get a true reading any longer. The forces of the electromagnet are greater than the natural magnetism of the Earth.
An electromagnet could be used for the pointer of a compass, but there are many reasons why a simple permanent magnet works far better for this particular job.An electromagnet:Requires a power source.Has far more mass that would have to balance on the center pin.A reliable contact mechanism would have to be invented to connect the needle to the power source....these among others...
The real question should be how do you get current to flow through a compass needle.