A desert is cooler because of the loneliness outside
Its not the air thats slow its you
It is a function of the "dew point" of the air at any given moment. If relative humidity is high, the dew point will also be high and the swamp cooler air will be relatively warm. If relative humidity is low, the dew point will also be low and the swamp cooler air will be relatively cold. A swamp cooler in Phx AZ will put out air about 30 degrees less than the outside air, and works more efficiently when the humidity outside is very low.
The Unit being in Sun or Shade will have NO effect on how well a Swamp Cooler performs. Operation of Swamp / Evaporative Cooler effectiveness is determined by Ambient temperature / dew point and relative humidity. They are optimum in Dry / Hot / Low Humid climates such as found in the South West Desert areas of the U.S. The higher the Humidity / Dew Point, the LESS EFFECTIVE a Swamp / Evaporator Cooler will be. They cool by adding moisture to the Air. So the higher the Humidity is, the more the moisture content is in the air already, thus being less effective. Air can only support so much moisture before it starts to condensate. ( You will then start to feel Sticky and less comfortable ) Again, the Unit being in the Sun, verses being in the Shade, WILL NOT change the Coolers effectiveness in operation.
I have one and i know you just need to install it in and then turn the knob if your does not operate this way get an instuction mannule
Yes, it is recommended to leave windows open when using a swamp cooler. This allows for proper circulation and ventilation, as the cooler draws in fresh air from outside. Keeping windows open also helps to prevent the air in your space from becoming too humid.
The high humidity and cloud cover of a swamp act as a blanket, holding in the day's heating. The desert lacks humidity and clouds so the heat radiates back into space.
Swamp coolers only work well in areas with low humidities, such as the desert. They are only capable of lowering the temperature by about 20 degrees if the humidity is quite low. An air conditioner would be much cooler.
A desert cooler, also called a swamp cooler, depends on low humidity and evaporation to cool the air. It loses efficiency when the humidity is high, such as during the rainy season. Less water will evaporate when the air is already nearly saturated with water.
replacement bearing cooler
On humid days, such as during the rainy season, swamp (desert) coolers are not very efficient at cooling the air. Air conditioners are not affected by high humidity.
The desert (swamp) cooler depends upon evaporation of water for cooling. During the rainy season the air is already pretty much saturated with water vapor so little water evaporates from the cooler and they become inefficient. They are most efficient when the relative humidity is below 20%.
form_title=Swamp Cooler Installation form_header=11553 Please specify the type of space the swamp cooler will be used in.*= () "Single Family Home () Mobile Home () Garage, warehouse, etc." Where would you like the swamp cooler installed?*= () Roof () Wall () Window () Attic Can you explain how the swamp cooler will be regulated?*= () On/off switch () Thermostat () Want recommendation What number of rooms would you like the cooler to be connected to?*= {Select One,1,2,3,4,5,6,7,8,9,10 or more}
Put a lot of copper pennies in your swamp cooler. The copper will kill the mold using IONs or something.
They tend to prefer the desert. The swamp is too wet and musky
80 is pretty warm I would not think you need any humidity unless you are in the desert. If I was in the desert, I would want to turn on the swamp cooler.
the best thing for a swamp cooler leak, is a copper pipe, or plumbing sealant, its similar to jb weld, only its waterproof, and made for leaks.
Home windows do have to be open when you are using a swamp cooler. You do not open them all the way, they should be opened part way.