A map of a circuit is not a volt. A map of a circuit is referred to as a schematics chart. The schematics chart details the path of the circuit, from beginning to end.
A volt can not be connected to a circuit.
It depends on the use it is being put to. It is sufficient for a 24 volt circuit. Too much for a 12 volt circuit and too little for a 240 volt circuit.
If you are talking about a 6 volt coil, yes, so long as the contacts are rated for the 230 volt circuit. If you are talking about 6 volt contacts, no, absolutely not.
The recommended wire size for a 220 volt circuit according to the 220 volt wire size chart is typically 10 gauge wire for a circuit with a maximum of 30 amps.
The current in a 220 volt circuit depends on the resistance of the load connected to it. Ohm's Law (I = V/R) states that current (I) is equal to voltage (V) divided by resistance (R). So, the current will vary based on the resistance of the circuit.
No, you cannot wire a 120 volt ballast to a 347 volt circuit. The ballast is designed to operate at a specific voltage, in this case 120 volts, and connecting it to a higher voltage circuit like 347 volts can damage the ballast and pose a safety hazard. It is important to match the voltage rating of the ballast to the circuit it will be connected to.
1 volt
It should work okay.
The recommended wire size for a 220-volt electrical circuit is typically 10-gauge wire.
Volt difference causes a short circuit! ChaCha
If a 1.5 volt battery is replaced by a 9 volt battery in a circuit, the current flowing through the circuit will likely increase. This is because the higher voltage of the 9 volt battery will provide more electromotive force, pushing more current through the circuit, assuming the resistance remains the same.
A volt meter will do the job.