answersLogoWhite

0

Is had to installed correct

Updated: 8/20/2019
User Avatar

Wiki User

10y ago

Best Answer

No, had to install is correct.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Is had to installed correct
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Which is correct we will install or we will installed?

we will install


Why does a truck jump like its out of timing since changing the spark plugs?

I would check the plug wires to see if they are installed in the correct locations.I would check the plug wires to see if they are installed in the correct locations.


What object is used to correct site for a newly installed DC?

Subnet


What is an Ethernet card?

When it is installed with the correct software, it allows a computer to connect to a network.


What is the correct name for the direction - distance plates often installed on pedestals at scenic lookouts?

The correct name for a direction/distance plate that is installed at scenic lookouts is called a ground plate. These may also be located on the ground, where it might be impractical to have a pedestal.


What size prop comes on a 90 Johnson?

The 90 hp Johnson outboard is not shipped with a propeller installed. The correct size is determined, and installed, when the engine is rigged on the boat.


Can linolium flooring be installed over tile flooring?

Properly. NO! The correct way to do it would be to rip out the tile and start from scratch with a new subfloor for the sheet vinyl to be installed on.


What is the correct height of a gas hot water heater installed in a garage?

THE PHCC recommends 24 "


How come empire earth 2 expasion wont work?

Make sure you are inserting the correct disk, and have installed it properly. Also, for it to work, you would have had to installed Empire Earth 2 first.


Will buying new parts for your tv lower its performance?

No, as long as the parts are the correct replacement parts and are installed properly.


What is the correct procedure to be followed when handing over maintained or installed equipment?

Suck the operator of like you never have before


Why would gas pour out of a carburetor on a 1969 Chevy pickup that a new kit has been installed?

Float level to HIGH, Needle and seat not installed correct are damaged. Carburetor not CLEANED correct. Fuel pressure to high. That engine should only have 6 to 9 lbs. of fuel pressure.