If you have to connect the neutral to ground to make the circuit work then you have an open neutral in your circuit. Be careful in handling the neutral as there can be voltage potential on the neutral if a load is connected. In a properly wired home that has been inspected by the local electrical inspector the neutral should be bonded to the ground at the main service distribution point. There will be a green screw that projects through the neutral bus and is threaded into the back of the electrical panel. This should be the one and only place in the whole electrical system where this neutral to ground connection takes place. Dangerous!!!!! The ground is the safety to prevent you from getting shocked due to a malfunctioning piece of equipment. By using the ground for a neutral you will be energizing the entire ground system of you house or business. Thus anything with metal on it and a ground wire going to it will be electrified if the ground fails at the breaker box or building ground rod. Do you want to take this risk? Not I..........
The Neutral is used to bring power back to the source to complete circuit
Black & Red are hot, and White is neutral. If it has no place to connect neutral connect neutral to ground.
Yes, you may connect the ground and neutral together as long as this is a replacement in an exsisting dwelling,for new construction you must have a four wire circuit with separate neutral and grounding conductor.It was never the intention of the code to make home owners replace exsisting three wire circuits with four wire when replacing equipment. .
The fuse will be blown off in case of any fault. But the circuit will not be isolated because of the presence of fuse in nutral line. current will still flow and the line will be so dangerous.
The neutral wire does carry current in a closed AC circuit. Clamp a clamp on amp meter around the neutral wire directly after the circuit load and it will read the same current as is on the "hot" wire.
short circuit
Connect to the circuit neutral wire which should also be white.
we use to connect elcb using hands. with help of skrewdriver
A phase leg connects to the neutral through the connected load.
Charging by conduction involves touching a negatively charged object to a neutral object. It can be dangerous when using a part of the human body as the circuit .
I think you probably mean 'lines', rather than 'phases' but, even so, your question is still confusing. However, if you connect any two lines together directly, you will create a line-to-line short circuit fault; if you connect any line and neutral together directly, you will create a line-to-neutral short circuit fault.
A multiwire branch circuit is consist`of two or more ungrouded conductors that has voltage between them and has a grounded conductor that is eoual voltage between each conductor connect to the neutral and it,s ground
The Neutral is used to bring power back to the source to complete circuit
If they are on the same circuit you only need 1 neutral wire in the circuit.
Black & Red are hot, and White is neutral. If it has no place to connect neutral connect neutral to ground.
IF Neutral is connected to the Switch then Live still exists on the socket even if the Switch is OFF.In such a situation a person can get a shock as Live can form a circuit thru the body to Ground.
I assume you are talking about 120volt electrical circuits ???? If so, just wire them in parallel. In other words, connect the black wire to line side on each circuit and the white wire to neutral on each circuit. The bare ground wire goes to ground (green) At each circuit will be 120 volts AC. Do not exceed the maximum current of the circuit breaker supplying the current (typically 15 - 20 amps)