0
Is it advisable to use a worn out surge strip with faulty wiring?
CurtJohns
No, it is not advisable to use a faulty power strip with damaged wires, as the user takes the risk of fire.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Why isn't it advisable to use a surge strip that's completely worn out?
The reason it is not advisable to use a worn out surge strip is that the surge protection is no longer available to protect your electronic device. It's best to purchase a new one.
What should you do to the surge strip if the circuit breaker fails to reset?
You should replace the surge strip if the circuit breaker fails to reset.
What should do if your surge strip catches on fire?
If the surge strip catches on fire, unplug it from the wall outlet and use a fire extenguisher or sand to smother the fire.
Does every surge strip have a built-in motherboard?
Yes, most of the surge strips have an in-built motherboard.
What is a surge strip?
A surge strip is an electrical device that protects your valuable electronics from dangerous power surges, spikes, and overloads. However, many surge strips they have in production today does not support protection against power spurts.
When was surge strips released?
The first surge strip was released in 1961. Olson Electronics distributed the strips.
Where can one purchase a power strip surge protector?
One can purchase a power strip surge protector online from websites such as Amazon, eBay, APC Power, Home Depot and Lowe's. One can also purchase these in store at Lowe's and Home Depot stores.
Is a surge strip the same as an uninterruptible power supply?
No. A surge strip is a power strip with a surge protector that will shut itself off if it detects a significant surge in power. It protects devices from electrical damage by flipping itself off or in some cases blowing it's own fuse. A UPS, uninterpretable power supply, also acts as a surge protector but with the added bonus of having battery power to compensate for lack of power temporarily. This gives the user time to shut down the computer and save their work so as not to loose any progress made. Hope this helps!
What would make my 2000 SVT Contour lack power and surge only when hot?
possibly a faulty fuel pump.
Why does a Power Strip have cable attachments?
It is a separate component and is used for grounding only. Usually on a TV or electronic power strip for convenience. Most likely the power strip has built-in surge suppression. It is designed to disconnect the load, like your TV, from an over-voltage surge such as could happen during a lightening strike. The in and out cable connectors provide the same type of surge protection from a high voltage that may be induced on the antenna or cable source for the TV during a lightening strike.
Where is the low coolant level sensor on a 1999 cadillac deville?
The sensor is located in the bottom of the surge tank and will require replacement if faulty.
What causes hot and cold water to surge through the shower head?
A malfunctioning water heater can cause hot and cold water to surge through the shower heat. A faulty water pump can also cause this problem.
