0
Is it bad to constantly be unplugging and plugging in a router?
Wiki User
∙ 13y ago
yes. this can be very bad and dangerous if you want the best and longest performance out of your wireless router. it can deplete the connections on the circit board or overall just burnup the processing chips and capacitors(yes old school).
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What causes router to go bad?
plugging it and unplugging it. spilling water on it, humidity, high usage constantly, operating at extreme temps. the usual computer problems
Why are my PS3 and xbox360s internet connections really bad while all my other devices are fine?
If you are using Wifi your router may not be built for gaming. If its plugged directly into the modem it may be a error from unplugging from the Internet to many times. and if its a direct to the router connection try resetting the modem removing the battery then reset the router.
Can your temperature sensor cause the temperature light to stay on?
If it is going bad it can cause the light to come on. Try unplugging it and plugging back in and see if the light shuts off. Usually you can go to Autozone and they will test the code and see what is tripping to set the light off.
1999 Chevrolet Cavalier temperature gauge not working?
First try unplugging the coolant temp. sending unit and plugging it back in(may just be bad connection at the plug), next replace the temp. sending unit if the plug-in thing didn't work.
Why is your lan light orange instead of green?
If it was green before and turned orange it means you have problems with your wired connection. It can be as simple as unplugging and plugging the cable. And as bad as that the NIC went dead. Start with testing the card using ping 127.0.0.1. It will test your NIC. Then test the card on another end of the cable and test cable.
Why does my router keep rebooting when I try to access Wifi I can connect to it fine via a wired connection but when I try to use my laptop on WiFi it automatically shuts down the router?
If your router keeps shutting off and rebooting, when you try and access WiFi, it sounds like your router is bad. Another sign the router is bad is your ability to use a wired connection without a problem.
What does code po403 means?
EGR Flow circuit malfunction ....which means power interrupted in the circuit. Try unplugging it then plugging back. Be sure to erase codes. If that dont work,take it off and check that it will move freely and it is not covered with exhaust carbon buildup. It is a high dollar part and very hard to diagnose if it is bad/going bad. Maybe if you know someone to borrow theirs for a moment, put it on your car to see if it solves your problem.
Why would the electronic climate control and fuel gauge not work on 1991 deville?
Your problem is that your BCM (body control module) is bad. A used one can be purchased for about $70. To install the BCM, take out ONLY your glovebox. Located right behind the glove box is the BCM, its as easy as unmounting it and unplugging the chord and plugging it into the new one and remounting it. 10-15 fix max.
Is plugging a vacuum into a power strip bad?
A power strip normally has a built in breaker, so this is not a bad idea. Keep in mind though, you won't want to take the chance of tripping the breaker if you have a computer plugged into the strip. In this case, plugging directly in the wall would be recommended.
Is sniffling your nose constantly bad for your sinuses?
no it is not
Why can not you smell?
Most likely you have a bad cold that is plugging up your nasal cavity, hindering your ability to smell properly.
Is it bad for your cell phone if plug it in while it still has a mostly full battery?
I think the only damage you can do is unplugging it before it is fully charged
