answersLogoWhite

0

If it is going bad it can cause the light to come on. Try unplugging it and plugging back in and see if the light shuts off. Usually you can go to Autozone and they will test the code and see what is tripping to set the light off.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What causes heat light to stay on?

A faulty temperature sensor can cause the ECm to think your engine is overheating, this turning the heat light on constantly. You should make sure that your engine isn't in fact overheating though.


Why would the servic engine light stay on on a 2002 trans am that has had all recommended service done and a new locking gas cap put on and hoses checked?

A malfunctioning sensor can cause the service engine light to stay on. A glitch in the computer can also cause the light to stay on.


Why does the ABS light stay on and the ETS light stay on?

Check your ABS sensor


Will the ABS speed sensor being bad cause the ABS light to stay on?

Yes! Brake light will stay on as well. May even mess with speedo up to certain speed.


What causes the ABS light to stay on?

The ABS light might stay on because of a sensor issue. The braking system of most vehicles has several sensors that can cause the light to come on and stay on. This could also be a problem with brake pads or calipers.


Why does your motion sensor security light stay on all night?

Either the sensor is not working properly or you have enough motion such as trees swaying, etc. to cause the sensors to constantly activate the lights.


How do you shut off abs light on a 1998 ford ranger and what might cause the light to stay on?

If the ABS light is on , a malfunction has been detected . It could be a fuse , a sensor , or some other problem


How can I make a motion sensor light stay on continuously?

To make a motion sensor light stay on continuously, you can usually override the sensor by flipping the switch on and off quickly. This will keep the light on until you manually turn it off again. Keep in mind that this may vary depending on the specific model of the motion sensor light.


What would cause a 1988 Ford Crown Victoria check engine light as well as low fuel light to stay on?

Not positive which one but it sounds like a computer or sensor problem


Why do both the handbrake light and ABS lights stay on in my 2003 Protege 5?

The actual cause was a defective wheel speed sensor which when replaced reset the indicators.


Daylight driving lights stay on when it is light out?

Dirty/faulty dawn/dusk light sensor


Why does your 1998 Nissan maxima brake light stay on?

How do u remove break light sensor