It isn't dangerous to have a DC voltage on a co-ax input to a television but there is a small risk that it may damage the input. It certainly isn't regarded as good practice to allow DC voltages to reach inputs unless they are intended to deal with DC.
There are a variety of devices such as signal amplifiers that can be fitted close to an aerial and powered by a power supply at the other end of the co-ax cable. In these cases, a DC voltage is applied to the cable but is not allowed to pass further down the co-ax cable to the television itself. If the cable is disconnected from the television, in some cases, the DC voltage can be measured but this is normally just some leakage from the DC filter in the power supply. Once connected to a television input, the voltage will normally disappear.
If there is still a concern, talk to a qualified TV service engineer who will be able to identify the source of the 12V.
DC is more dangerous because its magnitude doen't goes zero instantly after every half cycle as in case of AC .
With an appropriately rated DC to DC converter.
no
12 volts DC
can ou step down 36 volts dc to 12 volt dc using batteries
by going to the DC shoes website
no actually dc current is more dangerous than ac because dc is a direct current and has no current zero condition ,which is very dangerous and do not leave us if we get shock while ac current leave us when we get shock
WHEN DOES THE LAST TRAIN LEAVE NEW YORK GOING TO dc
No.
DC Pierson was born on 1984-12-27.
yes it is 230 v is deadly, it doesn't matter if it's ac or dc. Some people say one is more dangerous than the other. That implies that there is some voltage, lower than 230 v, at which one will kill you but the other will not. There is no conclusive evidence for that, so it can't be said that ac is more dangerous than dc or vice versa.
There's no such phenomena as negative DC. Minus sign only means, that current is flowing the other way than you are measuring. It's danger is exactly the same as "positive" DC.