Want this question answered?
400
The pressure in the ocean would change the shape of a glass bottle. If the water pressure was high then it would squeeze the bottle until it shattered.
Well, This is very hard but u pour it in and out and in and out in and out and in and out and in and out in and out and in and out and in and out in and out and in and out and in and out in and out and in and out and in and out in and out and in and out and in and out in and out and in and out and in and out in and out and in and out and in and out in and out and in and out and in and out in and out and in and out and in and out in and out and in and out and in and out in and out and in and out and in and out in and out and in and out and in and out in and out and in and out and in and out in and out and in and out. And then it will evaporate.
because all the space in the syringe is taken up by water. If you squeeze the syringe it will break.
Air pressure can buckle the sides of a plastic bottle. If a bottle is capped, it isolates the air inside. At the time the cap went on, inside and outside air pressure were equal. Cool the bottle and the sides will buckle in because the inside air cools, becomes less dense and then its pressure goes down. Cap an empty soda bottle and stick it in the fridge for fifteen or twenty minutes. Look at what happens. Want more drama? Same empty soda bottle. Run a couple of cups of hot water out of the tap in it. Cap it and shake it for ten seconds or so. Uncap it and dump out the water and replace the cap right away. What is in hand is a bottle of pretty warm air that is isolated inside the bottle. Put that in the fridge for ten minutes. Major buckling.
an empty water bottle
Nothing. The bottle is now truly empty.
A constant volume.
full or empty?
400
The ullage is the empty space in a closed bottle. So in a bottle of water, the ullage is between the surface of the water and the bottom of the bottle cap.
The answer depends on how big the bottle is and what material it is made of.
You get a empty water bottle, fill it up with hot water into the bottle and apply it to that area.
Actually it does empty its content until the level of the liquid inside and outside is the same.
It will get cold.
Whenever the water bottle is empty
The bottle begans to fill with water and begans to float.