0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you remove an exhaust manifold?
You just unbolt it. You first have to disconnect the exhaust pipe from the manifold then remove whatever you have to allow you to access the bolts and remove the manifold. It varies greatly from engine to engine. Some are easy and some are very hard.
Why loss of power on 2005 Skoda octavia 1.9tdi?
Air flow meter goes on these fairly regular. Cheap part and easy to fix. It causes the car to run normally but the turbo won't work hence the loss of power. Check it out.
Where is the thermostat on a 99 Honda Passport?
Not an easy job.You need to remove the intake manifold plenum to do it.
How to change a brake light bulb on a Skoda Fabia?
undo the side panels in the boot to gain access to the bulb panel which should just unclip, then just replace the bulb and clip it back in place agan. its the top bulb on the octavia skoda estate. its really easy i did it first time. Make sure you replace your spare bulbs though.
Replace a starter on a 2004 odyssey?
no need to pull manifold. remove battery and plate. remove red wire to starter and remove two bolts. easy
How do you change the water hose under the intake?
What's under the intake is not a hose, it's a pipe which a hose attaches to behind the intake manifold near the firewall. If the hose is leaking, it's a relatively easy task to replace it. If the pipe is leaking, you will have to remove the intake manifold which is not an easy task (minimum 6 hours to remove and replace the manifold!)
How do you remove a broken exhaust manifold bolt from a 2006 Jeep Commander?
The first step is to remove the manifold. If the bolt is sticking out, remove with a vise grip pliers or stud remover. If broke off flush, drill and extract with an easy out or try to weld a nut to it and turn out that way.
Where are the spark plugs on a 2.5L dodge stratus?
there are 3 in the front which are easy to get at, then there are 3 in the back under the intake manifold. they are a little difficult to change, because of the manifold secure bolts, but you should be able to get to them, once you remove the upper manifold.
How do you replace starter on 2002 Toyota tunder?
The starter is located under the intake manifold. You will have to remove the intake manifold being very careful not to drop any of the bolts into an in port. The starter is fairly easy to access once the manifold is off.
How do you change a cold start valve on a 1991 Volvo 740?
Remove the gas line (depressurize it first), and remove the electrical connector. Then remove the two bolts that fasten the valve to the intake manifold. The valve is below the manifold so it is not very easy to access.. Installation of the new one is reverse of the removal.
How do you replace the air filter in the 2005 suzuki aerio?
It is pretty easy to replace the air filter in a 2005 Suzuki Aerio. Remove and open the air intake manifold, remove the old air filter, put in the new filter and reattach the air intake manifold.
What type of drillbit used to drill broken manifold stud?
The type of drill bit used to remove a broken manifold stud is an extractor or easy out. A hole is drilled into the stud and then the extractor is used to dig in and unscrew the bolt.
