Hey Jeremiah==It is possible but VERY expensive. GoodluckJoe
I have not done this but one time I replaced a motor in a 1992 GEO metro 5speed with another metro motor from an automatic I had to remove the torq converter and flywheel and put the flywheel and clutch on it from the oringinal one I had on it and it worked. hope this might help a little.
Converting a manual transmission to automatic transmission is not possible but you can replace a manual transmission to an automativ transmission . That is also an expensive deal.
Yes it is possible with a bellhousing adaptor plate..... but in short no......Buy the right tranny......or a flux capacitor......
How do you replace a transmission modular automatic on a 1998 tahoe
Yes, that is possible. But you would need a donor car in order to have all the parts necessary. Otherwise the cost of doing this would be astronomical. My advice is to sell the Honda with an automatic transmission and buy a Honda with a manual transmission.
The 2002 PT cruiser is equipped with an automatic transmission. The automatic transmission does not have a standard clutch. The transmission will need to be completely rebuilt.
Yes, but you have to remove the automatic transmission housing, and you have to replace the Torque Converter with a standard transmission clutch that matches the type of transmission with which you are mating the engine.
if you're looking to replace your automatic with manual the only option is the 91-94 Mazda Navajo's manual.
No you don't have to drop the transmission in order to replace the slave cylinder, but be careful because it can easily be stripped.
you cannot change the CLUTCH on an AUTOMATIC transmission. wow
Automatic Transmissions are such complex things that I would leave that to a transmission shop to do or, if I needed a new Automatic Transmission I would purchase a used or rebuilt one and replace the bad one myself.
If done by a competent mechanic.
It depends on where the slave cylinder is located. If it is inside the bell housing you will have to remove the transmission.
I have an automatic. But (usually) The Slave Cylinder is on the transmission, easily accessible and easy to replace. It's a small thing on the transmission (usually) with a rubber boot with a piston inside. Have to bleed the clutch master cylnder as well. -CE
take it to a transmission specialist to replace the filter the oil pan on transmission must be removed,this generally means raising transmission off the mounts
Remove the Ford Ranger automatic transmission drain plug. The drain plug is in the bottom of the transmission. Allow the oil to drain out and replace the plug. Fill the transmission with new transmission fluid.
if it's an automatic you can replace it with any accent automatic transmission from 1995 to 1999, you will have to change the neutral safety switch on the transmission on some trans. cheers!!!!!
It would be cheaper to repair or replace the automatic transmission. There are too many differences between a standard transmission and an automatic to economically swap in a standard.
The Neutral safety switch is located on the back of the automatic transmission. it is quite simple to replace. It is probably easier to replace from under the vehicle, but it is accessable from the top if your vehicle is not equipped with ABS.
Automatic transmission oil filters ware located inside the transmission, under the transmission oil pan. You have to remove the transmission oil pan to replace it and then you will need to refill it with new transmission fluid.
No, they are designed differently.
To replace the slave cylinder on this vehicle you will have to remove the drive shaft and then the transmission. The slave cylinder will be bolted to the inside of the bellhousing. The transmission is very heavy so be very careful.
bring it to transmission shop