If its contained within a suitable enclosure , eg ip65 which does not allow the ingress of water or dust externally .
The biggest circuit breaker in any home is the main breaker located in your main breaker panel that is installed where your electrical service cable comes into your home.
A 15 amp circuit breaker will handle this situation very well. The smallest home breaker is rated at 15 amp.
You use the correct size breaker depending on the size wire in the circuit. If the circuit is wired with AWG #12 wire use a 20 amp breaker. If it is wired with AWG #14 wire then use a 15 amp breaker.
Yes, it will be protected by a circuit breaker or fuse. The normal rating of the circuit breaker or fuse is 25% more than the maximum current expected, or the maximum current allowed for the cable size, whichever is lower.
If it is a properly wired circuit (according to code) in the home, the breaker for that circuit will trip deenergizing the shorted circuit. If it is not properly wired, it could get hot and start a fire and possibly burn down the home.
The biggest circuit breaker in any home is the main breaker located in your main breaker panel that is installed where your electrical service cable comes into your home.
No, this isn't necessary. The circuit breaker protects your home by avoiding an overcharging caused by a short-circuit. It's advisable blocking the access to the breaker.
The breaker panel.
The breaker panel.
A 15 amp circuit breaker will handle this situation very well. The smallest home breaker is rated at 15 amp.
Not unless you change the wiring for that circuit. The breaker protects the wiring and if you install a 40 amp breaker on a 15 amp wire circuit you will have a fire in your home.
A breaker box
a circuit breaker trips on overload,if this breaker has tripped many times it may be worn out,if there is a overload happening the breaker is doing it s job keeping you safe.Main breaker needs to be replaced when your meter has been pulled(removed from metersocket)Have a electrician look at it and verify problem, you should not attempt to change out yourself it will be live.......
Yes but it's redundant and may cause unnecessary "tripping" of the circuit. The GFCI circuit breaker is intended to protect an entire receptacle circuit whereas a GFCI receptacle is designed to protect only that receptacle and any which are provided power from its load side. (downstream)
first thing to try is checking your breaker box. its possible the breaker has just went out. the breaker box is usually located outside or if you are living in apartment its usually in one of the closet's.
You use the correct size breaker depending on the size wire in the circuit. If the circuit is wired with AWG #12 wire use a 20 amp breaker. If it is wired with AWG #14 wire then use a 15 amp breaker.
Yes, it will be protected by a circuit breaker or fuse. The normal rating of the circuit breaker or fuse is 25% more than the maximum current expected, or the maximum current allowed for the cable size, whichever is lower.