answersLogoWhite

0

shouldn't run anything else, my 94 doesnt.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you remove compressor belt on a 2000 mercury villager?

Loosen the tensioner locking bolt and and back off the screw. Consult a manual if you are not familiar with how to do this.


Do you have to remove the engine in a 2001 mercury villager to change the timing belt?

No, you do not have to remove the engine.


How do you remove the thermostat on a 2000 mercury villager without removing the timing belt?

There is no need to remove the timing belt to change the thermostat.


How do you install a fan belt on a 1998 Mercury Villager?

The Villager has an electric fan and does not use a "fan belt".


How do you remove the alternator from a 1995 mercury villager?

Remove the right wheel, then get down underneath it, remove the splash shield, back off the adjuster, remove the belt, and unbolt it.


Does a 2001 Mercury Villager have a timing chain?

No , the 3.3 litre V6 engine in a 2001 Mercury Villager has a timing BELT


Does the 1998 Mercury Villager Van LS V6 have a timing belt or timing chain?

The 3.0 litre V6 engine in a 1998 Mercury Villager has a timing BELT


Does the 94 villager has timing belt or chain?

The 3.0 litre V6 engine in a 1994 Mercury Villager has a timing BELT


1999 3.3 Mercury villager have a timing chain or belt?

Timing BELT


How can you eliminate compressor belt noise for a 2000 mercury villager?

Most belt noise is caused when one of two conditions. Either the belt is loose or it is worn (indicated by smooth shiny surface on the pulley side) and should be replaced.


When should you change the timing belt on a 2008 mercury mariner?

when should i change the timing belt on a mercury villager


How do you replace water pump on a 1997 mercury villager?

You will need to drain the water from your 1997 Mercury Villager cooling system. Remove the water pump belt. Remove the water pump hose. Remove the water pump retaining bolts. Reverse the process to install the new water pump.