That is fairly accurate. I like to use 1.5 times the width of the nut.
Most thumbs are about 2 cm in diameter and about 7cm in height.
My thumb, from the palm-thumb joint to the thumb-tip is 7.0 cm.
Minimum length of splice is determined by local building codes, but a good rule of thumb is to make the splice length at least 20 times the bar diameter, but always at least 18" minimum.
The ratio of the human thumb to the length of the arm is usually 1 to 15. The thumb's length can fit into the size of the arm an approximately 15 times or more.
If you mean the palm of my hand, yup! It is exactly 3 times the length of my thumb. (:
50 cm
Yes.
The answer will depend on what characteristic of the thumb you wish to measure: length, width, mass, volume, resistance to pressure, etc.The answer will depend on what characteristic of the thumb you wish to measure: length, width, mass, volume, resistance to pressure, etc.The answer will depend on what characteristic of the thumb you wish to measure: length, width, mass, volume, resistance to pressure, etc.The answer will depend on what characteristic of the thumb you wish to measure: length, width, mass, volume, resistance to pressure, etc.
An inch
· theory · thesis · thief · thoughts · thread · thrills · throat · thumb · thunder
gab
it was as big as England's castle!