Yes. There are four bolts at the rear or the seat (two on each side) that fasten the seat to the floor slides. There are also two bolts (one on each side) which fasten the seat to the floor slides. To gain access to the front bolts, locate and remove the plastic plugs in the trim panel. Now, find a buddy to help remove the seat from the car. It is heavy and awkward.
The rear seat does not come out. The middle seat is removable, after which you can slide the rear one up.
There are several things that can cause your 1998 Mercury Villager rear fan to stop working. The most common cause is a disconnected or corroded ground wire.
Top rear of engine directly under the air intake tube/throttle body.
Valve cover gasket?
On a 2000 Mercury Villager : The washer fluid for the rear liftgate is supplied by the same reservoir as the windshield ( located in the engine compartment )
On the rear side of the throttle body.
No such option was available.
The washer fluid for the rear liftgate is supplied by the same reservoir as the windshield in a 2000 Mercury Villager
Look on the bottom or rear of the radiator or just remove the lower radiator hose
If it has a rear orifice it's in the rear unit under the roof panel.
Conventional drum brakes.
That is incorporated with the latch assembly.