Want this question answered?
Electrical Sheathing is various forms of metallic or non-metallic covering over conductors. Nonmetallic-Sheathed Cable is what is known by the brand name Romex.
No, according to the electrical code the cable has to have a underground rating. That said many home owners do install indoor rated cable in PVC black water pipe and bury it for outdoor installations.
Yes unless there were some overarching electric code reason why conduit was used in lieu of Romex. if in doubt ask an electrician.
In romex, 14-2 means two conductors, 14AWG each, and 14-3 means three conductors, 14AWG each. Note: Normally, romex has a ground, so the designation is more likely to be 14-2/G or 14-3/G.
The key is that you don't want to cause over-heating in wire. The answer is you can probably do what you want unless it involves high current and a small cross section in wire mold such that the Romex could generate too much heat. You could always strip out the wires inside the Romex and just run them in the wire mold.
NM (Non Metallic) Cable.
Not legal
Romex is a manufacturer's wire cable trade name, the 10 refers to the size of the wire inside the cable set. A #10 AWG copper conductor with an insulation factor of 90 degrees C is rated for 30 amps.
Modern NM/ Romex
THHN is a heat resistant thermoplastic insulated conductor, usually a single conductor. Romex is a brand name for a nonmetallic sheathed cable, it has multiple conductors inside, the insulated ones are insulated with THHN insulation.
A #10 copper wire in a NMD90 cable is rated at 30 amps.
Copper Romex cable. Usually in sizes AWG 14 (15 A or less), AWG 12 (20A or less) and AWG 10 (30A or less) for some appliances like electric stoves. Larger service entrance cable is required and larger cable between service boxes if there are multiple electric panels. Romex is a trade name of a product of the Rome cable company proper name is non metallic sheathed cable NM Service entrance cable is NM SE the neutral conductor is wrapped around the other conductors serving as guard and drain if you sign a contract with an architect and it says in the contract to use romex you may use any brand of NM the electrical inspector will back you in court and the architect will pay his lawyer, the court, and the inspection agency lots of $
many wires are. such as 14-2 Romex. 12-2 Romex. Any THHN wire of any size. This list is very long. If you have a speific application then you need to check the NEC 2005 Table 310.13 Conductor Applications and Insulations.
Electrical Sheathing is various forms of metallic or non-metallic covering over conductors. Nonmetallic-Sheathed Cable is what is known by the brand name Romex.
No, according to the electrical code the cable has to have a underground rating. That said many home owners do install indoor rated cable in PVC black water pipe and bury it for outdoor installations.
Copper or aluminium.
Assuming 220 volts service 5000/220 = 22.72 Amps. That equates to 10 AWG Romex.