0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Is the word with out one or two words?
It is one word
Is the word downstairs one of two words?
No, the word "downstairs" is a single word, not two words.
Is homesick two words or one word?
It is one word.
Is workplace one or two words?
Yes it can be one word.
Is one another one word or two words?
it is two words
Is screw driver one word or two?
two, two words put together
How do you remove the tilt knob on a 04 dodge ram?
With a T20 torx screw driver. It is held on by one screw.With a T20 torx screw driver. It is held on by one screw.
What is the compound word in this sentence -- The bus driver took an alternate route to the airport?
Compound words are two words combined into one. Since "airport" is made of two words-- air+port, it is a compound word.'Bus driver' is also considered a compound word, in the open form.
What type of screw driver do you need to for the tippmann 98?
A small one that fits.
What are the kinds Screw driver?
Phillips head (the star lookin one) and Flat head (the flat one) :)
How many syllables is the word screw?
one
What is the purpose of a diode in a cordless drill or power screw driver?
The purpose of a diode in a cordless drill or power screw driver is to allow electricity to flow in one direction only and blocks the flow in the opposite direction.
How do you set idle for ATVs?
There is an idle screw on the side of the carb its the one you can turn by hand if you have to use a screw driver its probably not the idle screw. turn it CW to increase and ccw to decrease.
How do you take off rotors on a 97 Volkswagen Passat?
Take off the caliper. Then the saddle. There will a screw holding the rotor on you will have to take that out. The best way to take it out is to buy a impact driver. But if you dont have one then just get the right screw driver and hit it with a hammer this will cause the screw to loosen.
What is the Ideal Mechanical Advantage when a screwdriver with a handle of radius 1.2 cm is used to remove a screw in the back of a computer and the screw moves out 0.20 cm on each turn?
There is no advantage whether the handle is 1.2 cm or 10 cm, the screw will still only make one revolution. The reason being is that both the screw driver and the screw become part of the whole. The only increase in the screws revolutions is if the screw driver is geared to make more than one turn of the screw.
How do you replace your board on your skateboard?
You buy a new one and use a screw driver to take off all the wheels and stuff and switch the boards and screw them back on. :/
What kind of people that uses Philips screw driver?
that guy off one guy one srewdriver might use them
