0
Is the 2000 Suzuki VS800 intruder fuel injected and shaft driven?
Wiki User
∙ 15y ago
All of the VS800 Intruders are, to my knowledge, shaft drive. Likewise, I know that the 2000 model used a choke system for cold starts and since fuel injection does not require a manual choke, then I can safely say that this model is not fuel injected.
Therefore, in my round about way, we have this:
Fuel injected? No.
Shaft driven? Yes.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What is the Front fork tube diameter on a 1996 Suzuki Intruder VS800 motorcycle?
The front fork tubes in a 1996 Suzuki Intruder VS 800 are 40mm.
How many quarts of oil does a 2003 Suzuki intruder vs 800 hold?
2.5 quarts of 10W40 without a filter change, 3 quarts with filter change, according to my 2003 Suzuki VS800 factory manual.
Where is fuel filter on suzuki intruder 800?
The VS800 has a screen inside the tank that they (Suzuki) call a fuel filter. The say it never needs replaced. Other than that.. there is no fuel filter.
How do you open the fuse box on a suzuki vs800 intruder?
To locate your fuse box, check your owners manual. You should find the exact location and instructions for how to open and find each fuse.
Do motorcycles need water?
If the motorcycle is liquid cooled (like the Suzuki Intruder VS800) it will need water and anti-freeze and will have a radiator. Air cooled motorcycles do not need water. Some air cooled motorcycles have a oil cooler (like the Suzuki Intruder VS1400) which looks like a small radiator, but not many.
2001 suzuki intruder vs800 oil?
10/40 regular or synthetic I would not use 10/40 unless it was synthetic. Regular 10/40 breaks down too quick. You can also use 10/50 20/50 15/50
Where is battery on 1993 suzuki intruder?
it (assuming it is a VS800) is in a trap door under the bike between the frame. disconnect the negative lug (left side) then the positive (right side) (this will be a small slotted screw viewable through a postage stamp sized window on the side of the battery cover) from underneath you remove the two front trap-door bolts and the cover will swing downward (be ready to support it as it swings) to add clearance have the back wheel up on a small thin board and one of equal size under the side stand for more info on suzuki intruders and boulevard series bikes check with www.intruderalert.com
You just replaced the battery on your 1994 Suzuki Intruder VS800 and now when you ride down the road all your lights are flashing constantly Do you now need to replace the stator?
Sounds like you have broken a ground wire in the vicinity of the battery or you have left a wire off. If the problem persists after you have checked thoroughly around all the connections you can check the stator. Disconnect the stator. Check with an ohmeter, there should be no connection between any of he three statro pins and ground. Start the bike, there should be about 60 volts AC between any two pins.
How do you remove the seat of a 2002 Suzuki VS800?
I'm not sure if there is prescribed "quick-collapse and remove" system for this vehicle, I would consult an owner's manual to make sure. Otherwise, through the careful manipulation of the seat's primary anchor points (usually 4 points) with the use of pry-bars, saw-zalls, and wrenches, most seats can be removed from most vehicles. If access to the seat's anchoring system is not easily visible, you may need to manipulate the adjacent seats as well to provide access (see above for directions on seat manipulation). Sometimes, the vehicle's intracate electrical components are mounted to or beneath passenger seats. If this is the case with your Suzuki, I recommend assessing the need for said electrical components prior to prying, cutting, or in any other way manipulating parts or pieces of electrical systems, or other mechanical systems attached to any seats being considered for manipulation of any kind, since such manipulation will likely deem your electrical component as irrepairable. Since seats make natural collection places for such items as half-eaten candies, coinage, dirt/dust, and liquids, it is advisable to wear gloves and breathing masks during seat manipulation processes, including pre-manipulation investigations. Lastly, if you are the original owner of your vehicle, you would naturally be aware of any of your seats being used for drug trafficing purposes. However if you are not the original owner of your vehicle, be prepared to potentially discover toxic substances such as methamphetamines, crack, speed, or any of those substance's necessary ingredients, particularly if you bought your vehicle from any undocumented immigrants within our country or from residents from rural locations who are missing more than 4 teeth and are under 70 years old. Otherwise, removing the seat from your Suzuki should be uneventful. By the way, I don't recommend removing any seat without abiding by the specific instructions normally contained in a vehicle owners' manual for seat removal. Remove right side frame cover. Remove the bolts and washers on both sides of the seat Pull up on the front of the seat and slide it forward. I see some people have way too much time on their hands.
