nope
F = Fast 5A = 5 amp L=Low Break Capacity
There is not a difference between IBM lto5 tape drives 3588 f5a and hp lto5 tape drives eh957b. They are both a software tape.
No. A slow blow fuse is intended to survive a short overload from the startup of a piece of equipment, usually a motor or power supply. If you use a fast blow fuse in this application, it will tend to blow unexpectedly.Motors usually pull four times their rated running current on startup, but only for a very short period of time. The slow blow fuse, or slow trip circuit breaker, is designed to handle this. Similarly, power supplies need to charge the primary filter capacitor from zero voltage in one line cycle on startup. Worst case is turning on the power switch at the peak of the line cycle. Inductance of the transformer (if present) and dynamic resistance of the diode mitigates this, but there is still a larger than normal current transient. Again, the slow blow protective device allows this in the short term.Hy i'm GbRlEuEeN, i used f10a(fast) fuse to replace t5a fuse(slow) but was on audio sistem(subwoofer) and i will change back as soon il get the t5a. ( i tryed f5a first but blowed instant at power up.
It is usually fuse number 12 in the fuse box and is a 7.5amp fuse.
H.G. Fuse - Horn Gap Fuse D.O.Fuse - Drop Out Fuse
which fuse is the heater/AC fan fuse
The 1998 Cadillac dashboard fuse is a 30 amp fuse. The fuse can be found in the fuse box. The location of the fuse will be listed on the inside cover of the fuse box.
The side of the light fuse can be found in the fuse box. You can remove the fuse with a fuse puller or a sense of needle nose pliers. A fuse puller can be found in the fuse box.
fuse
First locate the fuse in the fuse box, then pull old fuse out and insert new fuse.
The auxiliary plug fuse can be found in the fuse box. The location of the fuse can be found on the inside cover of the fuse box.