no the cat not to close to the bad cat there is bad cat and goodcat so the good cat cannot be close to badcat
A black cat would be more unlucky than a white cat. An example of this would be the belief that a black cat crossing your path leads to bad luck. There is no bad luck that a white cat would give you.
They were close of being endangered. They were used for cat shows. The tailless cat is also high valued.
A cat crying is not a bad omen. There is nothing that is going to happen negatively as a result of a cat's behavior. If a cat is crying, something is wrong with the cat. Seek medical attention for the animal is there is no comfort for the cat at home in a reasonable amount of time.
It's a close relative of the skunk.
The error code E 30 for a CAT sit down lift truck is not listed online. However, you can call any CAT dealer and they can give you the error code reasons.
Post catalytic too rich. 2096 is to lean one of several things is going on and none are cheap. 1) the pre cat is bad not doing its job of scrubbing. 2) pre cat o2 sensor is bad causing car to run rich and post cat sensor is picking it up or 3 post cat sensor is bad and not reading correct. or any number of the 3. there is the possibility of dirty injectors from crap gas causing it though the pre cat sensor should read the same thing ... not sure what that code is. I'm gonna do a full system clean now to see if that will fix it or at least help it.
If the cat is plugged up you would have a lack of power. If the insides of the cat are broken up you should have a check engine light come on. The post cat oxygen sensor would detect the cat is not doing it's job and set a code.
02 sensor. Bank 1 Sensor 3, post cat
(front) sensor 2 is after the cat
bank one is close to the fire wall sensor one is before the cat
Sensor 2 is allways further down the pipes. It is allways after the Cats Are your cats Missing and is this setting the code? Bank one is the driver side. Sensor two will be the sensor either in or below the small cat close to the engine.
Oxygen sensor bank 2 (pass side) sensor 2 ( after cat) circuit
you need to find out what sensor it is there is two there is an upstream witch is sensor 1 is before the cat and a downstream witch is sensor 2 is after the cat. bank 2 should be passenger side
CODE 55 IS THE BEGINING AND THE END OF CODE FLASH CK FUEL code 55 is the end of codes, check egr valve for damage look closely does it appear melted ? If so drill 2 holes one in each exhaust pipe as close to cat. convertor as possible , drive to shop and have cat. convertor and oxygen sensor replaced.
The check engine code PO136 means the O2 sensor circuit malfunction
code P0420 is set when the computer detects a fault in the three way catalytic converter circuit. there is a oxy sensor before and after that cat, and if the sensors do not read what they are supposed to be, it sets a code 420, which could be a failed sensor, or a failed catalytic converter, or a failure in wiring. Depending on high mileage or not, it is most often the cat worn out or, a sensor worn out.
These codes are for the O2 Sensor - One is for the heater core inside the O2 Sensor, the other is the sensor. It's gone bad! - No Activity, is what it will read. It's the (Bank 1 Sensor 2) Not sure where it's located, ibelieve it's right in front of the Cat. good luck.