Yes.
No. The engine mount may be in the way depending on the engine.
Its located on the side of the transmission, real simple to replace.
No. But you do have to support the engine from underneath and remove passenger side motor mount.
No the number and the style of electrical plugs are different. Plus the 1997 has an extra motor mount.No the number and the style of electrical plugs are different. Plus the 1997 has an extra motor mount.
2.5L and 3.0L, inside the distributor. 3.3L, pass side of engine, under the coil, near the motor mount.
On a six cylinder the starter is on the front of the engine, behind the motor mount. On the four cylinder, the starter is on the rear under the intake manifold.
Yes it will but the gear ratio will be a slight bit different.
Well. if its your front mount, then you jack up the engine, your mount is located at the very front, at the bottom, then you remove the single bolt that goes through the mount, remove the mount, and installation is the reverse of removal.
That should go somewhere to the frame as a frame ground.
is there a way to fix or replace just the rubber in the mount
It definitely is a possible cause of it jerking, if it's not an engine mount, service the transmission
Loosen the transmission mount retaining bolts. Loosen the back to engine retaining bolts. Jack the transmission of approximately 1 inch. Remove the transmission mount bolts. Remove the transmission mount. Reverse the process to install the new transmission mount.