A. dimensionless
KR and KK are not dimensionless.
"Dimensionless" means it doesn't have a unit.
No. "Dimensionless" means there are NO units involved.
Yes. Look at the Wikipedia aritcle on "dimensionless quantity". Here are two examples: 1. Angles, when measured in radians, can be considered the ratio of the arc of a circle to the radius. The result is a dimensionless number. 2. The coefficient of friction, which is the ratio between two forces. Dimensionless quantities often appear as a result of taking the ratio of two measurements.
The coefficient of friction is dimensionless; it has no units.
The coefficient of friction is a scalar quantity which has no direction which does not have an angle.
It is a dimensionless parameter since its just a ratio between two quantities of same unit.
The coefficient of friction is dimensionless.
A. dimensionless
A simple coefficient chart works best. However, in the event you do not have access to such a chart; here is the general coefficient information that can be used to calculate Storm water Runoff: 1) Smooth, Impervious Surfaces, i.e., Tile, Roofing materials, Concrete walkways has a runoff coefficient of approximately 90% 2) Gravel surfaces and paved asphalt surfaces have a runoff coefficient of about 80% 3) Mitigated, engineered and or loose soils have a coefficient rating of 60% 4) Natural soils like that found in an undisturbed forest has a general coefficient rating of approximately 30% 5) Built landscape areas like "Green Roofs" should hold to and strive to reach the target of a 30% runoff coefficient rating. Use this calculation to calculate runoff: (CA) X (R) X (E) X (0.6) = Area runoff in gallons. Understanding the equation: (CA) = Catchment area in Sq. Ft. i.e., 1 Acre = 43,560 Sq.Ft. (R) = Rainfall expressed in inches (E)= efficiency expressed in decimal (0.6) = Gallons per Square feet for every inch of rain
i guess the question should be coefficient of static friction force.if it is so then it is just a dimensionless quantity signifying the degree to which the frictional force can oppose relative motion and prevent any relative motion.
i guess the question should be coefficient of static friction force.if it is so then it is just a dimensionless quantity signifying the degree to which the frictional force can oppose relative motion and prevent any relative motion.
First, Manning's roughness coefficient is dimensionless. Second, usually unfinished concrete is assigned an n value of 0.014 whereas finished concrete is assigned an n value of 0.012.
the dimensionless numbers have the definition as that of dimensionless groups, and have all the properties which dimensionless groups have.
A friction is a force, so it would be measured in newtons. The coefficient of friction, on the other hand, is a ratio between two forces, so it is dimensionless.
Angles are not dimensionless.