0
No. It's passenger side. Get under your car and look for the fly wheel. It's on the front of the transmission and looks like a giant cog wheel. The starter will be almost touching the flywheel
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Does a Chevy 305 mount to the same transmission as a 43L?
Yes it will bolt right up to it.
Where can you check fuel pressure on a 1990 V6 43L Chevy Siverado?
The fuel lines around the filter; you will need an adapter.
Where is the engine timing mark on an '86 Chevy Astro 43L?
I have a '90 so I think it would be the same, on mine it is at the front of the engine on the bottom pulley. (crankshaft pulley or vibration dampener) To view the scale and mark I have to look down, a little on the drivers side of center. Beside the break resivour is a good viewpoint, looking just over the timing light. I have to run the timing pickup coil in through the drivers door or window and into the open doghouse cover. Good luck. God Bless!
How many kL are in 43L?
.043
How many liters in 43ml?
.43L. 1000ml=1L
Is there a thermostat 150 180 degree that will work in a Chevy S 10 V6 43L?
Don't know what year you have but some sensors are temperature sensitive and you should run a 195 degree thermostat.
Where is the exhaust gas recirculation valve EGR located on a 97 s10 Chevy blazer 43L AC v6?
It should be on the front of the intake manifold directly above and behind the water pump.
What transmission came in the 2002 43L s-10?
4L60/E l
How can you calculate the mass or the volume of 18-k gold?
43L of 18-k gold
Where is the Oxygen Sensor on a 90 Caprice V6 43L?
There is one before and one after the catalytic converter.
Where is the EGR on a 1987 43L v6 Chevy Astrovan?
The EGR valve on your Astrovan is on the backside of the intake manifold just under the throttle body attached by two bolts. After installing a new gasket be sure and torque the BOLTS to 17-18ft lbs or the NUTS (if yours has studs) to 15ft lbs)
How do you clean and adjust the throttle body on a 1991 Chevrolet S-10 blazer 43L is it the same as a carburetor?
There is no adjustment required, but you can clean it with a carb cleaner.
