answersLogoWhite

0

No it's water cooled, but it is supplied with engine oil pressure for the bearings.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

What motor comes in a 1991 Volvo 740 turbo?

BF230FT 2.3L 4 Cyl w/ Mitsubishi or garret turbocharger.


1991 Volvo 740 turbo hard start when cold?

My 1991 740 volvo turbo doesnt start specially during the morning.Is it comes with a cold start valve?


Where is the solenoid on 1991 Volvo 740?

This can not be answered, there are many "Solinoids" on this car that do many diferent things.


What causes a 1991 Volvo 740 to shut down when it hits 2 rpm?

The engine is not running!


Where can you get your vin decoded on a 1991 740 Volvo thanks Steve?

After searching everywhere I finally found the 1 site that does Volvo's, as I also own a 1991 740 GL Wagon with the Regina engine. This the site I had to go to http://www.vindecoder.net/. Good luck. Selina


What kind of Oil for a 1991 Volvo 740?

I have had volvo's for years and have had 4 740's including the one I have now and I use nothing but Castrol 20w50 in all of them, yes even in the winter. Also I have 2 740's now with over 300,000 miles on them.


What does an overdrive relay do in a 1991 740 Volvo?

allows power distribution to the overdrive solenoid for overdrive engagement.


How do you change the solenoid on the starter for a 1991 Volvo 740?

you have to take the starter out of the car and dismantle it.....it's an integral unit


Were is the fuse box on a 1991 Volvo 740?

under the ashtray, center console. pull out the tray and the little flap below it


Why is there a dark fluid that smells like gas in the coolant tank of 1991 Volvo 740 sedan?

bad head gasket.


Where is the fuel filter located on a 1991 Volvo 740?

Drivers side, inside of frame about where the trailing edge of the drivers door is.


Difference between Volvo 740 turbo and non turbo?

One has a turbocharger, and the other doesn't. The turbocharger is mounted on the exhaust manifold and uses the exhaust gases to drive a turbine which is connected to another turbine that forces fresh air into the intake manifold. This added air increases horsepower and torque.