Yes ... this is why the front end tends to nosedive when stopping. Some newer cars have achieved a perfected braking system where the total load is shifted equally between the rear and front breaks, resulting in a more comfortable stop.
The front brakes on any vehicle do most of the stopping. When you apply the brakes the weight shifts to the front of the vehicle. For this reason the front brakes are needed more than the rear. Try stopping a vehicle with just the hand brake which applies only the rear brakes.
No.
The actual brake will almost always be on the rear wheels. The lever will usually be in the center console, maybe shifted towards the driver's side.
You will find that the front brake rotors are located behind the front of your wheel spindle, (behind your wheel and brakes). There you will see the rotors.
towards the front of the vehicle
You have a serious brake problem. For your own safety have the vehicle towed to the garage of your choice for repair.
Year, make and model of vehicle would help along with front brake, rear brake or e-brake information.
EBD: Electronic Brake Distribution (or Electronic Brake-force Distributor) - alters how much of the brake force goes to the front and how much to the rear. Cars always have more braking on front as if the rears lock before the front then the car will spin. How much braking you can do with the rears depends on how much weight is in the vehicle so EBD dynamically adjusts this balance. Without it, the manufacturer sets up the balance so the rears don't lock when the vehicle is empty which is less braking than is possible when the vehicle is full.
There should be more braking power to the front wheels for two reasons. As the brake is applied there is a change in the balance of weight distribution on all four tires caused by the vehicle pitching down on the front. This places more weight on the front tires. If there was more braking taking place on the rear tires than on the front, there would become an oversteer condition and the back of the vehicle would skid out.
Brake dust!
To replace front brake pads on a 2002 Ford Mustang safely raise and stabilize the vehicle. Remove the wheels and caliper. Slide out the front brake pads and replace with new units.
Lift the vehicle, remove the tire, remove the brake shoe/caliper, and remove the old brake pad. Put in a new brake pad, replace the brake shoe/caliper, replace the tire, and then lower the vehicle.