0
I'm not sure what you mean by "interchangeable", if it's a fuel inj car from the factory, it should have what you need for FI, but if it was carbuerated, harness if different, painless performance has any and all make and models of new wiring harnesses, http://www.painlessperformance.com/ jr
What else can I help you with?
How do you hook up a Cd player to a 1993 caprice classic?
go buy a aftermarket wiring harness from any car stereo store and snap it in and follow the wiring colors and you are done..
Where do you find the electronic spark timing bypass connector on a 1992 caprice 305?
the bypass connector is located on the engine wire harness, next to the left valve cover (watching engine front) next to the air injection control valve.
How do you remove the ignition of a 89 caprice classic?
To remove the ignition switch from a 1989 Caprice Classic, start by disconnecting the negative battery cable to avoid any electrical issues. Then, remove the steering column covers by unscrewing the screws. Once exposed, locate the ignition switch, disconnect the wiring harness, and unscrew the ignition switch from its mounting. Finally, pull the ignition switch out of the column and replace it as needed.
Are jeep radios interchangeable?
Many jeep radios are interchangeable. Though a new wiring kit or harness may be required for a proper installation.
How do you take off light switch off a 93 caprice classic?
To remove the light switch from a 1993 Caprice Classic, start by disconnecting the negative battery cable to prevent any electrical issues. Next, gently pry off the switch cover panel using a flathead screwdriver. Once the panel is off, locate the retaining screws for the light switch and remove them. Finally, disconnect the wiring harness from the back of the switch to fully detach it.
How do you fix my turn signal switch on the steering wheel on a 83 Chevy caprice classic?
In most cases you will need to replace the turn signal switch on the steering wheel for your 1983 Chevy Caprice Classic rather than fixing it. To replace it, remove the horn pad and then use a steering wheel puller and compressor to remove the steering column. You will then remove the signal along with the wiring harness and bus fuses. Replace the signal and wiring and then replace the steering column itself.
1991 chey caprice classic and it just died at the store you thought it was the fuel pump because of no sound in tank?
i found out it was the wiring harness above the tank had a loose connection i fixed it and started write up even fuelpump made noise works great
How do you replace the alternator on a 1995 Chevy Caprice Classic?
Also in order to loosen the serpentine belt you have to use a wrench or something and turn on the bottom pulley....easy remove the serpentine belt for the fan area and remove the two bolts that hold the alternator down and unclip the wiring harness
How do you install an ignition switch on a 1986 Chevrolet caprice?
Attach the wiring harness to the and of your 1986 Chevrolet Caprice ignition switch. Slide the ignition switch into the ignition slot. Tighten the ignition switch with the retaining ring.
When removing an engine do you need the wiring harness?
If you are installing the engine in an exact model that the engine is coming out of, the harness should not be needed. If there are any changes in model, sensors or anything else then the harnesses will not be interchangeable.
Do you have the Wire harness 2007 Silverado Classic?
You can find the wire harness for the 2007 Silverado Classic at most Auto Zone stores or online at Auto Zone. You can also find this part online at Amazon or Parts Geek.
1989 Honda civic hatchback 1.5 dual point fuel injection changing over to multi port fuel injection do i need a wiring harness and ecu?
Yes
