97 honda accord headbolt specs
It is Located in top of the throttle body, it is a black plastic plug with 3 wires goin into it
Yes but it will send a code to obdII for faulty sensor.
1997 Honda accord special addition
yes, your lug pattern size is 4x114.3 for 94-97 Accords. All models.
It is probably just your exaust manifld cooling.
The valve is on the passenger side of the car follow the lower radiator hose back to the thermostat housing and it be top
The 1997 Honda Accord LX (either coupe or sedan) has 130 horsepower.
Not 100% but it should fit yes the accord 5 gen was from 94-97
Well i have a 97 accord...if you have a 94-97 accord the speed sensor will be right under the Throttle body, u will have to unplug a couple of sensors and pull your intake out and shine a light down there you will see it... its kinda hard to get it but not to bad... I have a 1990 and my speed sensor is located in the same place under the throttle body mounted on the transmission, be careful not to lose the tiny little pin while removing the two bolts.
No, the only transmission that fits exactly is a 94-97 Accord. The 90-93 Accord can be used, but you will need the 90-93 flywheel. Chuck
Pull the ashtray out and it is right there
with a screw driver
the gear is located on the speed sensor, but the speedo is electronic so you can program it instead...
In the Dist.
It has no governor. The speed is computer controlled.
There are a few reasons a 1997 Honda Accord may not start. It is possible that the battery is dead or that it is out of gas. Another possibility is that the starter is worn out.
CODE 10 for Accord Civic CRV CRX Del Sol Odyssey Prelude 85-98 86-98 97-98 85-91 93-97 95-98 85-98 = IAT Sensor (Intake Air Temperature) defective circuit or unplugged / defective sensor
It will not work. A 1993 Honda Accord has a 4x114.3mm bolt pattern. A 1997 Acura Integra has a 4x100mm bolt pattern.
97 honda accord