Dodge Ram
Dodge Colt

Is there a crack sensor on a 1993 Dodge Colt and where is it?

565758

Top Answer
User Avatar
Wiki User
2006-05-26 23:42:34
2006-05-26 23:42:34

It may be part of the distributor. Slightly older (1990) model colts have the crank angle sensor and top dead sensor in the distribuor.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

where is a ignitionmodule in a dodge colt a 1993

User Avatar

1989 dodge colt no start;noid light steady bright

User Avatar

I believe it is located under the distributor cap. At least that's where it is located on a 1991 dodge colt 1.5 litre.

User Avatar

Dodge Colt was created in 1970.

User Avatar

Probably 4-5 quarts Add 4 and check

User Avatar

mines a 1994 and its is basically the same as a 1993 and it holds 13.2 gallons

User Avatar

It means the oxygen sensor is not giving an input to the PCM. Either a bad O2 sensor or a wiring issue.

User Avatar

Pull out the little white ball on the front of the trans.

User Avatar

You are doing something wrong.. TAke it to the trans shop.

User Avatar

Brakes on a Dodge Colt? It would depend on what is wrong with them, what they are doing or not doing.

User Avatar

http://www.the12volt.com/installbay/vehiclewiring/1/yeard/Dodge.html Must register first before you can see the page. It's under Dodge Colt.

User Avatar

Have you tried the internet? Have you tried the Dealer? Still no luck? Head to the salvage yard with your tools and good luck

User Avatar

Why is 92 Dodge Colt gear shift hung in fourth gear?

User Avatar

You don't... You fix the problem and the it goes out all on it's own...

User Avatar

This is for COLT FIREARMS, not automobiles.

User Avatar

Dodge does not use inertia switches.

User Avatar

the fuel pump on a 1995 dodge colt is located in the fuel tank.

User Avatar

behind the radio, lower right it is also called the ignition relay. Napa is the only parts store that has it.

User Avatar

The starter on the 1993 Plymouth Colt is mounted on the back side of the engine (by the firewall), and below the intake manifold.

User Avatar

On the 94, the clutch gable goes through the firewall at the top on the drivers side of the engine compartment. The adjustment is where the cable meets the firewall.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.